SEAL-O-RING 2139250 - Caterpillar

Optional Features
The Optional Feature enable the Generator Demand feature to be activated or deactivated
Illustration 1 g02537196
Optional features screenThis screen is activated after the proper pass number is entered into the password setting.
Illustration 2 g02537197
Optional features screen activated (1) Generator demand control switchGenerator Demand control switch (1) enable the generator demand feature to be activated or deactivated.Data Table Interface
General Information
The EMCP 3.S Data Table Interface is designed to provide a third-party automation system with an interface to gather values from the switchgear, and if specified and applied, control the system.The EMCP 3.S Data Table Interface (DTI) provides data over either an RS-485 serial link via ModbusRTU, or an ethernet connection via ModbusTCP.
Illustration 3 g02509956
Data table interface location in MCP (2) Data table interfaceThe EMCP 3.S DTI controller has two separate independent ethernet ports (Ethernet A and Ethernet B). Ethernet B is dedicated for use as a third-party interface via ModbusTCP. Serial port RS-485B is dedicated for use as a third-party interface via ModbusRTU.Hardware
The EMCP 3.S Data Table Interface has two ethernet ports, one RS-232 port, and two RS-485 ports. Only Ethernet B and RS-485B ports are available for use as customer interfaces.RS-485A
The RS-485A port can be used to communicate to other modbus slave devices. The RS-485 is not available for use as an interface as a modbus slave, simply because the data the RS-485 can access is limited due to the RS-485s physical placement on the controller.The RS-485A port supports the following settings as defined in table 1.
Table 1
Setting    Available Values    
Baud Rate
    0 = 2400 bps
1