SEAL-O-RING 2191897 - Caterpillar

Remove Crankshaft
Start By:a. remove timing gear coverb. remove flywheel housingc. remove pistons and connecting rod assembliesd. remove crankshaft rear seal and wear sleevee. remove crankshaft front seal and wear sleeve Check the bearing caps for a number as to their location. If a number can not be seen, put a number on the left side of the cylinder block and the bearing cap. 1. Remove bolts (1) that hold main bearing caps (2) to the block, and then remove main bearing caps (2). 2. Install one of the bolts from the front pulley in each end of the crankshaft.3. Fasten a hoist to crankshaft (3), and remove crankshaft (3) from the block. The weight of the crankshaft is 159 Kg (350 lb). If new main bearings are not to be installed, keep the old bearings with identification as to their location in cylinder block. 4. Use tooling (A) to remove the crankshaft gear.5. Use tooling (B) if necessary to remove the dowel and the pin.Install Crankshaft
If the crankshaft journals and bores for the block and rods were measured at disassembly and found to be within specifications, no further checks are necessary. However, if the serviceman still wants to measure the bearing clearance, Plastigage is recommended. Lead wire, shim stock or use of a dial bore gauge can cause damage to the bearing surface. The service man must be very careful to use Plastigage, use tool (B) correctly. The following points mut be remembered.1. Make sure that the backs of the bearings and the bores are clean and dry.2. Make sure that the bearing locking tabs are properly seated in their slots.3. The crankshaft must be free of oil where the Plastigage touches it.4. If the main bearing clearances are checked with the engine upright or on its side, the crankshaft must be supported. Use a jack under an adjacent crankshaft and hold the crankshaft counterweight and hold the crankshaft against the crown of the bearing. If the crankshaft is not supported, the weight of the crankshaft will cause incorrect readings.5. Put a piece of Plastigage on the crown of the bearing half that is in the cap. Do not allow the Plastigage to extend over the edge of the bearing.6. Install the bearing cap using the correct torque-turn specifications. Do not use an impact wrench. Be careful not to dislodge the bearing when the cap is installed.7. Do not turn the crankshaft with the Plastigage installed.8. Carefully remove the cap but do not remove the Plastigage. Measure the width of the Plastigage while it is in the bearing cap or on the crankshaft journal. Do this by using the correct scale on the package. Record the measurements.9. Remove the Plastigage before reinstalling the cap.10. When using Plastigage, the readings can sometimes be unclear. For example, all parts of the Plastigage are not the same width. Measure the major widths to make sure that they are within the specification range. Also experience has shown that when checking clearances tighter