SEAL KIT-H.CYL 2216304 - Caterpillar

Specifications
Illustration 1 g00404226
Input Transfer Gears
(1) Input gear. (2) Gap. (3) Bolt. (4) Bearing cage. (5) Bearing cage. (6) Bolt. (7) Gap. (8) Housing. (9) Output gear.
Introduction
This adjustment procedure is used to set the end-play in the input and output gears of the input transfer gear case. Adjustment Procedure
Adjustment Procedure for Bearing End Play
Note: Before you assemble the components, make sure that the bearing cups are seated in the housing and in the bearing cage. Also, make sure that the bearing cones are seated against the gear shoulders. Use a 0.038 mm (.0015 inch) shim or a feeler gauge.Note: End play for input gear (1) and output gear (9) is 0.15 mm (.006 inch) to a maximum of 0.20 mm (.008 inch).Adjustment Procedure for the Input Gear
Position housing (8) horizontally with the opening for bearing cage (4) at the top. Place input gear (1) in housing (8). Place bearing cage (4) on the housing. Do not use shims or seals.
Install two bearing cage bolts (3) in bearing cage (4) at a 180 degree interval. Tighten the two bearing cage bolts finger tight. Alternately tighten each bolt by one-fourth of a turn to an equal torque. Torque for the bearing cage bolts 9 N m (7 lb ft).
Rotate input gear (1) at least three turns or rotate input gear (1) until the input gear turns freely.
Again,