SEAL AS 2232028 - Caterpillar

Illustration 13 g00590920
Install bolt (36), the washer, and the clip to the lubrication pump. Install bolt (34), the washer, and angle (35) to the lubrication pump. Connect swivel tee (33) to the elbow on the vent valve.
Illustration 14 g00590914
Connect hose assembly (32) to the union bulkhead. Install tube assembly (31) to the check valve. Install two clips (30) and (29) to tube assembly (31) .
Illustration 15 g00590910
Connect wiring harness (28) to the level switch at the electrical connection. Connect wiring harness (27) to the pressure sensor at the electrical connection. Connect wiring harness (26) to the solenoid valve at the electrical connection.
Close the door assembly to the lubrication pump.
Illustration 16 g00590906
Position plate assembly (25) to the platform and the engine end frame. Install four bolts (24), the washers, and the nuts that secure plate assembly (25) to the platform and the engine end frame.
Illustration 17 g00590905
The view is under the back of the platform on the right side of the engine end frame.
Connect wire harness (23) at the electrical connection.
Illustration 18 g00590901
Position support bracket (22) to plate assembly (19) on the platform. Install two bolts (21) and the washers that secure support bracket (22) to plate assembly (19) on the platform.
Illustration 19 g00590899
Connect hose assembly (20) to the air tank. Install bolt (17) (not shown) and the washer that secures two hose clamps (18) to plate assembly (19) .
Illustration 20 g00590895
Connect hose assembly (16) to the air tank. Connect three hose assemblies (15), (14), and (13) to the air dryer.
Illustration 21 g00590893
Position plate assembly (12) to the platform and the engine end frame. Install four bolts (11), the washers, and the nuts that secure plate assembly (12) to the platform and the engine end frame.
Illustration 22 g00590887
Connect wire harness (1) to the flood lamp at the electrical connection. Install three clips (10), (9), and (8) that secure wire harness (1) to the platform.
Illustration 23 g00590885
Install two clips (7) and (6) that secure wire harness (1) to the platform.
Illustration 24 g00590881
Install two clips (4) and (5) that secure wire harness (1) to the platform.
Install bolt (2) and the washer in order to connect grounding strap (3) to the platform.
Illustration 25 g00590879
Open the door assembly to the electronic control box on the left side of the platform.
Connect wire harness (1) at the three electrical connections on the electronic control box. Close the door assembly to the electronic control box.End By:
Install the cab. Refer to Disassembly and Assembly, "Cab - Install".
Charge the air system. Refer to Disassembly and Assembly, "Air System Pressure - Purge/Charge".