SEAL-O-RING 2287092 - Caterpillar

Function and Navigation Keys
Reference: For a full explanation of the use of the function keys and the navigation keys that are referenced in this section, refer to Systems Operation, "Electronic Control Module (Generator Set)"
Illustration 1 g02118437
EMCP 4 Control System Panel
(1) Display screen
(2) F4 Soft key
(3) F3 Soft key
(4) F2 Soft key
(5) F1 Soft key
(6) Control key
(7) AC overview key
(8) Engine overview key
(9) Main menu key
(10) Warning Indicator lamp (yellow)
(11) Alarm acknowledge key and silence key
(12) Shutdown Indicator lamp (red)
(13) Event reset key
(14) Event log key
(15) Run key
(16) Auto key
(17) Stop key
(18) Escape key
(19) Up key
(20) Right key
(21) OK key
(22) Down key
(23) Left keyInitial Setup
Information from the EMCP 4 is displayed on the display screen (1). Press the main menu key (9) to get to the main menu options.Press the "OK" key (21) to select one of the main menu options.The keypad is also used to change the set points. Press the "OK" key (21) to change a set point. Use the navigation keys to increase or decrease the value. Press the left navigation key (23) or the right navigation key (20) to change the digit that is to be adjusted.Note: The EMCP 4 panel will power up to the "MAIN MENU" screen.Menu Maps
The maps in this section are to be used as a guide when programming the EMCP 4. Maps are provided for all versions of the controller.
Illustration 2 g02141887
Illustration 3 g02141992Programming the Display Preferences
The preferences affect the way data is viewed on the display screen. Change the configuration as needed to meet local requirements.To program the display preferences, perform the following menu options.
Press the escape key (18) as many times as necessary to go back to the "MAIN MENU" display.
From the "MAIN MENU", press the navigation keys to highlight the "PREFERENCES" option. The following parameters can be changed or viewed:
CONTRAST
PRESSURE
TEMPERATURE
VOLUME
CIRCUIT BREAKER SYMBOL
LANGUAGE
Press the "OK" key (21) to select "PREFERENCES". "CONTRAST" will be highlighted.
Press the "OK" key to select the contrast level. The contrast can be adjusted from low to high. The display will show a status bar representing the current contrast level.
Use the navigation keys to adjust the contrast to the desired level, and then press the "OK" key (21) to save the new contrast setting.
Press the navigation keys to highlight "PRESSURE". Then press the "OK" key (21) to select the pressure function. The available options for pressure measurement are "kPa", "PSI", and "BAR". The display will list all three options, with the current option highlighted.
Adjust the pressure to the desired measurement unit by using the navigation key, or the soft keys. Then press the "OK" key (21) to save the pressure