SEAL-PACKING 2332799 - Caterpillar

Removal Procedure
Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00521941
Illustration 2 g00581011
Loosen set screw (2) in order to remove knob (1) from the door handle.
Illustration 3 g00581017
Use a screwdriver in order to remove caps (4) from pull handle assembly (3).
Illustration 4 g00581021
Remove bolts (5) in order to remove pull handle assembly (3).
Illustration 5 g00581025
Remove truss head screws (6) in order to remove panel assembly (7). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-9613 Silicone Sealant 1
Illustration 6 g00581025
Verify that all of the components of panel assembly (7) are clean and free of foreign material prior to installation.
Inspect all of the components for wear and replace the components, if necessary. Note: Apply Tooling (A) to the back of panel assembly (7) prior to installation.
Use truss head screws (6) in order to install panel assembly (7), as shown.
Illustration 7 g00581021
Use bolts (5) in order to install pull handle assembly (3).
Illustration 8 g00581017
Install caps (4) onto pull handle assembly (3).
Illustration 9 g00581011
Position knob (1) onto the door handle, as shown. Tighten set screw (2).