SEAL-WIPER 2334667 - Caterpillar

Assembly Procedure
Note: Cleanliness is an important factor. Before the assembly procedure, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Lint may be deposited on the parts which may cause later trouble.
Check all of the O-ring seals and the components for wear or damage. Replace the components, if necessary.
Lubricate all of the O-ring seals lightly with the lubricant that is being sealed.
Illustration 1 g00560774
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install poppet (10), spring (9), retainer (8), and retaining ring (7) into relief spool (4), as shown.
Illustration 2 g00560773
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install spring (6), spacers (5), and relief valve (4) into relief valve (1), as shown.
The following steps outline the procedure for determining the correct number of spacers to be installed in the relief valve.
Attach the relief valve to the test stand. Tighten the mounting bolts to a torque of 48 4 N m (35 3 lb ft).
Supply oil at a rate of 18.9 .8 L/min (5 0.2 US gpm) to the relief valve.
Maintain a pressure of 931 34 kPa (135 5 psi) at the inlet of the relief valve. Add the spacers or remove the spacers in order to maintain the specified flow of oil.
Illustration 3 g00560771
Use two bolts (3) and the lock washers in order to install cover (2) and the O-ring seal onto relief valve (1). Tighten two bolts (3) to a torque of 48 7 N m (35.4 5.2 lb ft).
Illustration 4 g00560770
If necessary, install the plugs and the O-ring seals onto relief valve (1). End By:
Install the relief valve (torque converter inlet). Refer to Disassembly and Assembly, "Relief Valve (Torque Converter Inlet) - Install".