SEAL-O-RING 2343544 - Caterpillar

Remove & Install Oil Pump
Start By:a. remove oil pan Fluid Spillage ContainmentCare must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to "Tools And Shop Products Guide", NENG2500 for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose fluids according to local regulations and mandates. Depending on the configuration of the oil pan, there may be a long or a short oil supply tube used. 1. Remove oil supply tube and suction bell (2). Remove tube (1). 2. Remove bolts (3) that hold the oil pump to the cylinder block, and remove oil pump (4). The following steps are for installation of the oil pump.3. Put oil pump (4) in position on the cylinder block. Install the bolts that hold the oil pump to the cylinder block.4. Put clean engine oil on the O-ring seals of the tubes.5. Install oil supply tube and suction bell (2). Install tube (1).End By:a. install oil panDisassemble Oil Pump
Start By:a. remove oil pump Fluid Spillage ContainmentCare must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to "Tools And Shop Products Guide", NENG2500 for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose fluids according to local regulations and mandates.1. Remove the bolt and washer that hold the gear on the shaft. 2. Use Tool (A), and remove drive gear (1) from the shaft. Remove the key from the shaft. 3. Remove retainer (3) fro the bypass valve.4. Remove the spring and bypass valve.5. Remove cover (2) from the pump body. 6. Use Tool (B), and remove the bearings from the cover. 7. Remove gears (5) and (6) from pump body (4).8. Use Tool (B), and remove the bearings from pump body (4).Assemble Oil Pump
1. Use Tool (A) to install the bearings in the pump body. Install the bearings so the joint in the bearings is 30 15 degreesfrom the center line of the oil pump outlet passage (7). 2. Install idler gear (5) and drive gear (6) in the oil pump body. Put clean engine oil on the bearings and the gears. 3. Use Tool (A), and install the bearings in cover (2). Install the bearings so the joint in the bearings is 30 15 degreesfrom the center line of the bearing bores toward oil pump outlet passage (7).4. Install bypass valve (8), spring (9) and the retainer.5. Install the key on the shaft. 6. Install gear (1) on the shaft. Install the washer and bolt that hold the gear on the shaft. Be sure the pump turns freely after assembly. For more information regarding the oil pump,