SEAL KIT 2367329 - Caterpillar

Illustration 24 g01513997
CAESultra or MCU screen shot of machine dimensionsEnter correct details. Any errors transfer directly into the finished surface.
Measure the machine GPS Receiver offsets.ReferenceRefer to the sample CAESultra or MCU screen shot, Illustration 24, as a reference guide and template to record the machine dimensions. Note: The "X" measurement that is taken to the right of the centerline of the machine will be a positive number. The "X" measurement that is taken to the left of the centerline of the machine will be a negative number. Note: The "Y" measurement that is taken in front of the front axle will be a positive number. The "Y" measurement that is taken behind the front axle will be a negative number.
GPS x: Measure the distance from the center of the GPS Receiver (10) to the centerline of the machine.
GPS y: Measure the distance from the center of the GPS Receiver (10) to the center of the front axle of the machine.
Illustration 25 g01514069
(10) 353-2794 GPS Receiver (48) Phase CenterNote: The Phase Center is located 12.8 cm (5.0 inch) from the bottom of the receiver.
GPS z: Measure the distance from the Phase Center housing (48) of the GPS Receiver (10) to the bottom of the wheels.
Bucket Width: Measure the width of the machine from the outside edges of the bucket.
Wheel Base: Measure the distance from the center of the front axle to the center of the rear axle.
Maximum Reach: Measure the distance from the center of the front axle to the front edge of the bucket.
Wheel Radius: Measure the distance from the center of one of the wheels to the outside edge the same wheel.
Bench Height: Use the site-specific bench height.
Move the machine origin to a known point.
Compare the Northing, Easting, and Elevation.Calibrating Wheel Dozers and Landfill Compactors
Illustration 26 g01513906
CAESultra and MCU screen shot of machine dimensionsEnter correct details. Any errors transfer directly into the finished surface.
Measure the machine GPS Receiver offsets.Refer to the sample CAESultra and MCU screen shot, Illustration 26, as a reference guide and template to record the machine dimensions.Note: The "X" measurement that is taken to the right of the center line of the machine will be a positive number. The "X" measurement that is taken to the left of the center line of the machine will be a negative number. Note: The "Y" measurement that is taken in front of the front axle will be a positive number. The "Y" measurement that is taken behind the front axle will be a negative number.
GPS x: Measure the distance from the center of the GPS Receiver (10) to the centerline of the machine.
GPS y: Measure the distance from the center of the GPS Receiver (10) to the center of the front axle of the machine.
Illustration 27 g01514069
(10) 353-2794 GPS Receiver (48) Phase CenterNote: The Phase Center is located 12.8 cm (5.0 inch) from the bottom of the receiver.
GPS z: Measure the distance from the Phase Center housing (48) of the GPS Receiver (10) to the bottom of