SEAL-O-RING 2416200 - Caterpillar

Test Procedures for Arc Suppressors:
106-8704 Arc Suppressor
Illustration 13 g00651378
106-8704 Arc Suppressor
Place the multimeter in the DIODE test mode.
Place the red probe in the red terminal (positive terminal) of the multimeter.
Place the black probe in the black terminal (negative terminal) of the multimeter.
Place the red probe on Pin 2 of the connector on the arc suppressor. Place the black probe on Pin 1 of the connector.
The multimeter should display a value between 0.5 VDC and 1.0 VDC.
Place the red probe on Pin 1 of the connector on the arc suppressor. Place the black probe on Pin 2 of the connector on the arc suppressor.
The multimeter should display OL.
If the above conditions do not exist, the component should be considered faulty. The component will not provide adequate protection if the above conditions do not exist.
Replace the component if the component has failed. 3E-9169 Arc Suppressor and 130-8134 Arc Suppressor
Illustration 14 g00651923
Arc Suppressor with Sure Seal Connectors
(1) Pin 1
(2) Pin 2
Illustration 15 g00651621
Arc Suppressor with DT Connectors
(1) Pin 1
(2) Pin 2
Place the multimeter in the DIODE test mode.
Place the red probe in the red terminal (positive terminal) of the multimeter.
Place the black probe in the black terminal (negative terminal) of the multimeter.
Place the red probe on Pin 1 of either connector on the arc suppressor. Place the black probe on Pin 2 of either connector.
The multimeter should display a value between 0.5 VDC and 1.0 VDC.
Place the red probe on Pin 2 of either connector of arc suppressor. Place the black probe on Pin 1 of either connector on the arc suppressor.
The multimeter should display OFL or OL.
Place the red