SEAL AS-WATER PUMP 2492439 - Caterpillar

3600 Family Of EnginesDescription of Change: New power pad housing assemblies are used in the fuel injection control groups on the 3600 Family of Engines. The new housings have needle bearings in place of the sleeve bearings used in the former housing. The needle bearings will help reduce wear and excessive linkage movement that could occur with the sleeve bearings. A new shaft and lever are also used with the new power pad housing assemblies.Adaptable As: The new components in the fuel injection control groups used on 3606 and 3608 Engines are listed in Chart A. The new components in the fuel injection control groups used on 3612 and 3616 Engines are listed in Chart B. Illustration 1 shows the typical location of the new components. The new components are in effect with 3606 Engines 8RS326-Up, 3608 Engines 6MC261-Up, 3612 Engines 9RC26-Up, and 3616 Engines 1PD24-Up. The new components are adaptable to all earlier 3600 Family of Engines. When the new components are installed, use the procedure that follows to adjust fuel control linkage.
Location of new components.
Procedure To Adjust Fuel Control Linkage1. Loosen the locknuts and adjust governor control rod (3) to its minimum length.2. Remove synchronizing pin (1) from storage hole location on the power pad housing. Remove plug (2) and install pin (1) without washers in the hole where plug (2) was removed. 3. Rotate fuel stop lever (4) until it contacts synchronizing pin (1). Fuel stop lever (4) must remain in contact with synchronizing pin (1) during the linkage adjustment.4. Install synchronizing gauge, part of 6V6170 Timing and Fuel Setting Group, between the step on the fuel rack and the adjustment screw on the unit injector.5. Turn the adjusting screw on top of spring-loaded rod (5) as necessary until there is a slight drag on the synchronizing gauge as the gauge is moved out of position on the fuel rack.6. Repeat Step 5 for each unit injector fuel rack to be certain they are all synchronized at the mid point of control linkage travel. 7. Remove the plug and install dial indicator (6), part of 6V6170 Timing and Fuel Setting Group, in the power pad housing as shown (dial indicator must be installed as far in as possible). Set the dial indicator probe against fuel stop lever (4) and record the position of the dial indicator. Remove synchronizing pin (1) and put it in the storage location. Install plug (2) in the hole where the pin was removed.8. Move the governor to the full shutoff position.9. Adjust governor control rod (3) until dial indicator (6) moves -9.3 mm (-.37"). Tighten the two lock-nuts on rod (3). The total available travel of the dial indicator is approximately 9.4 mm (.37"), therefore the "zero" cannot be used.10. Remove indicator (6) from the power pad housing and install the plug in the hole where the indicator was removed.11. Check and adjust the Power Setting as per the information plate on the side of the engine. See Fuel