SEAL AS 2545665 - Caterpillar

Illustration 8 g01002993
Alternate Exit (5) . This message is located on the rear window and the inner window.
Illustration 9 g01429881
Engine Oil Fast Fill (6) . This message is located on the right side of the machine.
Illustration 10 g01429882
This additional message identifies the location of the fast fill connector for the engine oil.Engine Coolant Fast Fill (7) . This message is located at the rear of the radiator on the right side of the machine.
Illustration 11 g01429853
This additional message identifies the location of the fast fill connector for the engine coolant.Extended Life Coolant (ELC) (8) This additional message is located next to the cooling system pressure cap.
Illustration 12 g01425705
The cooling system is filled with Extended Life Coolant (ELC) from the factory.Fire Suppression System (Foam) (If Equipped) (9) (10) (13) . This additional message is located on the foam fire suppression system manual control.
Illustration 13 g01431884
This additional message is located on the right side of the radiator guard and in the operator station.
Illustration 14 g01431893
For more information on the foam fire suppression system, refer to Operation and Maintenance Manual, "Fire Suppression System (Foam)".Fire Suppression System (Dry Powder) (If Equipped) (11) (12) . This additional message is located on the right side of the radiator guard and in the operator station.
Illustration 15 g01431885
For more information on the dry powder fire suppression system, refer to Operation and Maintenance Manual, "Fire Suppression System (Dry Powder)".24 V Electrical System (14) . This additional message is located next to the jump-start receptacle.
Illustration 16 g01126478
This machine is equipped with a 24 V electrical system.Engine Oil (If Equipped) (15) . This message is located on the engine oil fill tube on the right side of the machine.
Illustration 17 g02448560
Cat DEO-ULS oils and oils that satisfy the "API CJ-4"and/or "ACEA E9" requirements are required for engines that are equipped with a Flow Through Diesel Particulate Filter.Diesel Fuel Requirements (If Equipped) (16) . This additional message is located next to the fuel tank filler cap.
Illustration 18 g02399176
Note: This information is pertinent to the United States of America (USA) and Canada.If applicable, consult the federal, state, local, and other governing authorities for guidance concerning the fuel requirements in your area.For more information about diesel fuels, refer to Special Publication, SEBU6250, "Caterpillar Machine Fluids Recommendations".Diesel Fuel Requirements (If Equipped) (16) . This additional message is located next to the fuel tank filler cap.
Illustration 19 g02052934
Use Ultralow Sulfur Diesel (ULSD) fuel.The United States (U.S.) Environmental Protection Agency (EPA) defines Ultra-Low Sulfur Diesel (ULSD - S15) as a U.S. diesel fuel with a sulfur content not to exceed 15 parts per million (ppm(mg/kg)) or 0.0015 percent by weight. Engines equipped with exhaust aftertreatment systems are designed to run on ULSD only. Use of LSD or fuels higher than 15 ppm (mg/kg) sulfur in these engines will reduce engine efficiency and engine durability. Damage to the emissions control systems will occur. Failures that result from the use of fuels are not Caterpillar factory defects. Therefore the cost of repairs would not be covered by a Caterpillar warranty.In Europe, ultra low sulfur diesel fuel