SEAL 2584430 - Caterpillar

Illustration 2 g01066228
There are several specific safety signs on this machine. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiarized with all safety signs.Make sure that all of the safety signs are legible. Clean the safety signs or replace the safety signs if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the safety signs, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety sign. Loose adhesive will allow the warning sign to fall.Replace any safety sign that is damaged or missing. If a safety sign is attached to a part that is replaced, install a safety sign on the replacement part. Any Caterpillar dealer can provide new safety signs.Do Not Operate (1)This warning label is located in the operator compartment on the front door post.
g00977514
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility.
No Clearance (2)This warning label is located at the center pivot.
g00038790
No clearance for person in this area when machine turns. Severe injury or death from crushing could occur.
"Connect steering frame lock between front frame and rear frame before lifting, transporting, or servicing machine in articulation area.""Disconnect lock and secure before resuming operation."Improper Connections of the Jump Start Cable (3)This warning label is positioned on the right side of the radiator guard above the battery box cover.
g00947488
There is limited battery access. Jump starting at the battery, or improper jumper cable connections at the starter, can cause explosion resulting in personal injury.Do not jump start the machine at the battery. Use the remote starting receptacle or jump start to the positive battery post on the starter.If remote starting receptacle can not be used, jumper cables may be used at the starter. Always connect the positive (+) cable to positive (+) terminal of the starter and connect negative (-) cable from external source to engine block. Follow procedure from the Operation and Maintenance Manual.
Pressurized System (4)This warning label is located near the cooling system pressure cap.
g00977524
PRESSURIZED SYSTEM: HOT COOLANT CAN CAUSE SERIOUS BURN. TO OPEN CAP, STOP ENGINE, WAIT UNTIL RADIATOR IS COOL. THEN LOOSEN CAP SLOWLY TO RELIEVE THE PRESSURE.
Do Not Weld on the ROPS (5)This warning label is located on the outside of the cab on the right side.
g01020165
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
"Rollover (ROPS) and Falling Object (FOPS) Protective Structure Certification""This structure, when properly installed