SEAL-ROD 2822181 - Caterpillar

Illustration 14 g00880016
Use bolts (28) and the washers in order to install plate (29) to the non-engine end frame.
Tighten bolts (28) to a torque of 240 40 N m (180 30 lb ft).
Illustration 15 g01243341
Use bolts (21) and the washers in order to secure plate (22) to pin assembly, as shown.
Tighten bolts (21) to a torque of 530 70 N m (390 52 lb ft).
Position Tooling (N) through the small hole near the center of plate (22) .
Measure the distance from the bottom surface of plate (22) to the pin.
Measure the thickness of plate (22) and subtract that amount from the original distance that was measured. This determines the amount of shims that is needed under plate (22) .
Illustration 16 g00880010
Remove plate (22) and add the measured amount of shims from Step 53.
Install plate (22) .
Install bolts (21) and the washers.
Tighten bolts (21) to a torque of 530 70 N m (390 52 lb ft).
Illustration 17 g00882007
Use Tooling (N) in order to measure the distance from the upper pin assembly (27) to the top of the flange on the top of the upper hitch on the engine end frame. Note: The distance will determine the shim pack that is required for the upper plate.
Illustration 18 g00882016
Remove plate (25) and add the amount of shims (26) from Step 58.
Install plate (25) and bolts (24) .
Install bolts (23) and the washers.
Tighten bolts (23) to a torque of 530 70 N m (390 51 lb ft).
Illustration 19 g00880007
Install bracket assembly (17), bolts (16), and the washers.
Illustration 20 g00880005
Install bracket assembly (15) with the valves.
Install bolts (14) and the washers.
Illustration 21 g00880004
Connect tube assembly (11), (12), and (13) .
Illustration 22 g00880003
Connect hose assemblies (9) at bracket (10) .
Illustration 23 g00880002
Connect grease hose assembly (7) to upper hitch (8) .
Illustration 24 g01243010
Connect harness assembly (5) .
Install bolts (6) and the clamp.
Illustration 25 g01242963
Connect hose assembly (3) to bracket (4) .
Illustration 26 g01242945
Connect hose assemblies (1) at relief valve (2) .
Fill the hydraulic tank for the implement and the braking system. The capacity of the implement and braking hydraulic tank is 173 L (45 US gal).
Fill the hydraulic tank for the steering system and for the hydraulic fan. The capacity of the hydraulic oil tank for the steering and hydraulic fan is 132 L (35 US gal).End By:
Install the cab. Refer to Disassembly and Assembly, "Cab - Install".
Install the center drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Center) - Remove and Install".