SEAL-O-RING 2R0239 - Caterpillar

Operation Mode Default Settings
Table 1
Parameter    STAND ALONE paralleling controls ON    STAND ALONE paralleling controls OFF    ISLAND
(GPC & LSM mixed)    ISLAND
(ALL GPCs)    UTILITY
(GPC controls PF)    UTILITY
(Cat DVR controls VAR)    
Cat DVR Voltage Regulator    
Load Compensation Mode
(0 is Off, 1 is Droop, 2 is Line Drop)     0     0     1     0     1     1    
Operating Mode
(0 is AVR[Off], 1 is PF, 2 is VAR)     0     0     0     0     0     2    
VAR Set point (% of Rated)     5.0 %     5.0 %     5.0 %     5.0 %     N/A     set to desired    
Table 2
Parameter    STAND ALONE paralleling controls ON    STAND ALONE paralleling controls OFF    ISLAND
(GPC & LSM mixed)    ISLAND
(ALL GPCs)    UTILITY
(GPC controls PF)    UTILITY
(Cat DVR controls VAR)    
GPC Paralleling Controller    
Power factor control     On     N/A     On     On     On     Off    
Power factor control set point     i0.95     N/A     i0.95     i0.95     set to desired     N/A    
Power controller "P set1 = " (4)     1825 kW (5)     N/A     1825 kW (5)     1825 kW (5)     set to desired     set to desired    
Reactive power load share (6)     Off     N/A     Off     On     Off     Off    
( 4 ) This setting is active when the base load select switch is switched to GPC (input term #6 Off)
( 5 ) Set to Prime Rating of machine
( 6 ) If the reactive power load share is set to on when operating in GPC and LSM mixed mode, VARs are not shared properly. When set to On, the analog VAR share line must be connected (unit to unit).
Table 3
Parameter    STAND ALONE paralleling controls ON    STAND ALONE paralleling controls OFF    ISLAND
(GPC & LSM mixed)    ISLAND
(ALL GPCs)    UTILITY
(GPC controls PF)    UTILITY
(Cat DVR controls VAR)    
Package Controls Configuration    
PCS (Paralleling Controls Switch: Off/On) (7)     On     Off     On     On     On     On    
Interconnect (kW) load share line (unit to unit) (8)             X     X            
Interconnect (VAR) share line (unit to unit) (8)                 X            
Install lead unit select jumper (on one unit only) (9)     X     X     X     X            
Interconnect lead unit select signal wires (unit to unit) (10)             X     X            
Connect utility breaker aux contact signal wires (11)                     X     X    
Connect utility transfer trip signal wires (12)                     X     X    
( 7 ) In the Off position the DC/DC power supply, GPC