SEAL AND TILT CYLINDER 2V4429 - Caterpillar

Remove four bolts (9) and spacer (11). Remove cover (10) and shaft assembly with the gasket.
Illustration 7 g00659290
Position the cover and shaft assembly in a vise. Remove nut (13) and bearing (12) .
Illustration 8 g00659291
Apply pressure to the top of shaft assembly (14). Release shaft assembly (14) from cover (10) .
Illustration 9 g00659292
Remove two rollers (16) and spacer (15) from shaft assembly (14) .
Illustration 10 g00659294
Remove two dowels (17), two springs (18), plate (19), and the spring from shaft (14) .
Illustration 11 g00659295
Loosen two bolts (20) .
Illustration 12 g00659296
Remove shaft assembly (21) from the housing. Remove link assembly (22) from the housing.
Illustration 13 g00659298
Remove bearing (23) from the housing.
Illustration 14 g00659299
Remove retaining ring (25) and washer (24). Remove shaft (26) and the bearing from the housing.
Illustration 15 g00659300
Disconnect two electrical wires (27) .
Illustration 16 g00659301
Remove two bolts (28) and the bracket with the sensor.
Illustration 17 g00659302
Remove two bolts (29), the washers, the nuts, and sensor (30) .
Illustration 18 g00659303
Remove two bolts (32) and the washers. Remove two bolts (34), four washers, and two nuts. Remove four bolts (33) and the washers. Remove two brackets (31) .
Illustration 19 g00659304
Illustration 20 g00659305
Disconnect two electrical wires (36) and remove sensor (35). Loosen bolts (39). Remove two arm assemblies (37) and sensor (38) .
Illustration 21 g00659308
Remove two retaining rings (41) and three washers (40). Remove shaft (42) and the bearing from the housing. Repeat this procedure for the other shaft.