SEAL-O-RING 3081875 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-9758     Jack Stand     1    
D     5P-0960     Grease Cartridge     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g00342997
Use a suitable lifting device to position bucket (6) to the machine. The weight of bucket (6) is approximately 1345 kg (2965 lb).
Apply Tooling (D) to all of the pin bores.
Illustration 2 g00342995
Align the bores of the bucket with the bores of the lift arms.
Put the washers in position. Install pin assembly (5) .
Install the spacer, the washer, and bolt (4) that holds pin assembly (5) .
Repeat Steps 3 through 5 for the pin assembly on the opposite side of the bucket.
Illustration 3 g01180339
Align the bore of bucket tilt link (1) with the bores of the bucket.
Install pin assembly (3) .
Install the spacer, the washer, and bolt (2) that holds pin assembly (3) .
Illustration 4 g00342992
Remove Tooling (A) from bucket tilt link (1) .End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".