SEAL AS 3081884 - Caterpillar

Make sure governor output lever is connected correctly to rack fork lever (1).1. Position base of governor (8) so side (A) of base is parallel with surface (B) of governor drive housing (12). Tighten governor mounting bolts (10).2. Now loosen adapter bolts (13).3. Move the governor and drive housing as needed until holes in cover (5) are in alignment with holes in accessory drive housing (11). Install, but do not tighten, the seven cover bolts (9).4. Tighten the six adapter bolts (13).5. Now tighten the seven cover bolts (9).6. After all bolts are tightened, check to be sure governor terminal shaft (4) has free rotation. Spring pressure in the Caterpillar 3161 Governor should cause the output terminal shaft to go back to the fuel-off position when released from the full-fuel position. Spring pressure in the Woodward UG8 Governor should cause the output terminal shaft to move when released from the full-fuel position, but it will not go all the way to the fuel-off position.7. If output terminal shaft does not turn freely, do Steps 2 thru 6 again.8. Put bracket (6) in position with open slots over bolts (3). Install washers and bolts (2) that hold bracket (6) to cover (5), but do not tighten these bolts.9. Tighten bolts (3) that hold bracket to governor first, then tighten bolts (2) that hold bracket to cover.