SEAL-O-RING 3102189 - Caterpillar

"Dash - PM 1 Reset"
This parameter configures the Engine Control Module (ECM) to allow the Caterpillar Driver Information Display (ID) to reset the PM 1 maintenance interval. The "Maintenance Indicator Mode" must be programmed to "On" for the PM 1 reset parameter to take effect.
Table 1
Default    Application    Alternative    
No     GM 530/540
Other     Yes    
Yes     GMT-560     No    "Dash - Customer Parameters"
This parameter configures the ECM to allow Cat ID to reset the following four parameters:
"Soft Cruise Control"
"Fast Idle RPM #1"
"Fast Idle RPM #2"
"Low Idle Engine RPM"Each parameter that is listed has a "Yes/No" option with "No" as the default.Note: This feature requires a Cat ID (version number 1.3 or higher).
Table 2
Default    Alternative    
No     Yes    "Theft Deterrent System Control"
When this parameter is used with a "Theft Deterrent Password", this parameter prevents the engine from starting unless the password has been entered via the dash display of the CAT ID. Before the operator can use the feature of theft deterrent of the CAT ID, the system must be turned on. In order to turn on the theft deterrent, use Caterpillar Electronic Technician (ET) to program the parameter for the theft deterrent to "Yes". The operator must first enter the password before the engine is shut off. This will enable the system. Enabling the system prevents the engine from starting without re-entering the password on the next attempted start. If this parameter is programmed to the "Auto-Enable" option, the system will automatically be armed when the keyswitch is turned off. Note: The "Auto-Enable" feature requires a Cat ID (version number 2.1 or higher).
Table 3
Default    Alternatives    
No     Yes
Auto−Enable    "Theft Deterrent Password"
The "Theft Deterrent Password" is the password that is required by the ECM before the feature of theft deterrent is enabled. After the theft deterrent is enabled, the "Theft Deterrent Password" is the password that is required to restart the engine. All of the characters must be uppercase. Four characters are available for the password. If the password is lost, the use of Cat ET and a factory password are required in order to start the engine.
Table 4
Default    Alternative    
0000     Four characters
A through Z
0 through 9    "Quick Stop Rate"
This parameter determines the rate of vehicle speed change that is used by the ECM to record a quick stop event code and a quick stop snapshot. Programming this parameter to 0 will disable this feature and no quick stop events will be logged. Each quick stop snapshot contains 60 frames of information. Frame 45 is the quick stop event. The quick stop snapshot also contains 44 frames before the quick stop event and 15 frames after the quick stop event. Each frame is separated by 1.0 second.
Table 5
ECM Snapshot Frame Data    
Engine rpm
Throttle position
Clutch switch     Vehicle speed
Cruise status
Brake switch    The most recent quick stop snapshot is stored in the ECM memory. When a quick stop event occurs the ECM replaces the