SEAL KIT 3197801 - Caterpillar

Attach a suitable lifting device to auger extension assembly (58). The weight of auger extension assembly (58) is approximately 210 kg (463 lb). Install auger extension assembly (58) to the main auger assembly on the tractor. Install the bolt, the washer, the nut, and auger segment (59) .
Remove the bolts, the washers, the nuts, two auger segments (60), and the tube from auger extension assembly (58) .
Illustration 47 g03654333
Remove the bolt, the washer, the nut, auger segment (62), and shaft (61) from auger extension assembly (58) .Note: Shaft (61) is not used on the 6.5 m extension kit.
Illustration 48 g03654334
Install auger bearing assembly (63), auger segment (62), the bolt, the washer, the nut to auger extension assembly (58). Place Tooling (A) under auger bearing assembly (63) .
Illustration 49 g03654335
Remove grease tube assembly (64), tube (65), two bolts (66), the two washers from auger bearing assembly (63) .
Illustration 50 g03654336
Attach a suitable lifting device to mainframe extension (67). The weight of mainframe extension (67) is approximately 93 kg (205 lb). Install mainframe extension (67), three bolts (68), and the three washers to support assembly (9) .
Illustration 51 g03657116
Loosen bolt (70) on bearing support (69) .
Install grease tube assembly (64), tube (65), two bolts (66), the two washers to auger bearing assembly (63) .
Tighten bolt (70) .
Illustration 52 g03653325
Install support plate (71), the four washers, and the four bolts.
Illustration 53 g03653326
Install tube assembly (72), the bolt, the washer, and the nut to mainframe extension (67) .
Illustration 54 g03653328
Install tube assembly (73) into tube assembly (72) .
Install tube assembly (73), the bolt, the washer, and the nut to support plate (71) .
Illustration 55 g03653329
Install tube assembly (74), bolts (75), the four washers, and the two nuts to tube assembly (72) .
Install tube assembly (74), the bolt, the washer, and the nut to bearing support (69) .
Illustration 56 g03657154
Adjust mainframe extension (67) and auger extension assembly (58) using the back tractor frame as a reference point. Once the parallelism between mainframe extension (67), auger extension assembly (58), and tractor frame is set, precede to tighten the four bolts on tube assembly (72) .
Illustration 57 g03653331
Attach a suitable lifting device to auger extension assembly (58). Remove Tooling (B) from under auger extension assembly (58).
Measure the distance from auger extension assembly (58) to the ground. The measurement should be equal to the measurement of the main auger assembly on the tractor to the ground.Note: A good starting point for the tube is approximately (B) 40 mm (1.6 inch) above the bearing support.
Tighten nut (70) .
Illustration 58 g03653332
Tighten two set screws (76) auger bearing assembly (63) .
Install the end gate and the bolts to the screed. Refer to Disassembly and Assembly, "End Gate– Remove and Install".
The left side of the machine is complete. Perform the procedure on the right side of the machine.