SEAL-WIPER 3199797 - Caterpillar

Illustration 1 g01991853
(1) Stick cylinder group (2) Fore boom cylinder (3) Stick group (4) Stub boom groupNote: All bores must be free of paint. Use the 5P-0960 Grease Cartridge in order to coat all bores for the pins, the stick, the stub boom group and the cylinder pin bores. (5) Lubricate the sealing lip of two lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install two lip type seals so that the lip type seals do not extend beyond the face of the boss.Note: Install the sleeve bearing (6) in the bore so that the part number of each sleeve bearing is facing outward. (6) 228-5617 Sleeve Bearing Inside diameter ... 100.29 0.04 mm (3.948 0.002 inch) Outside diameter ... 116.230 0.013 mm (4.5760 0.0005 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) (7) 113-2963 Pin As Pin diameter ... 89.850 0.025 mm (3.5374 0.0010 inch) Bore diameter for the pin ... 90.043 0.043 mm (3.5450 0.0017 inch) (8) 131-8552 Pin As Pin diameter ... 79.850 0.025 mm (3.1437 0.0010 inch) Bore diameter for the pin assembly ... 80.037 0.037 mm (3.1511 0.0015 inch) (9) 234-3803 Pin As Pin diameter ... 99.85 0.04 mm (3.931 0.002 inch) Bore diameter for the pin assembly ... 100.043 0.043 mm (3.9387 0.0017 inch) (10) As required, use the following shims in order to adjust the following maximum lateral clearance. The steel shim should be located at the boom side: Lateral clearance except for Gosselies facility ... 0.8 mm (0.03 inch) Lateral clearance for Gosselies facility ... 1.0 mm (0.04 inch) 133-2427 Shim Thickness of one shim ... 0.5 mm (0.02 inch) 093-0090 Shim Thickness of one shim ... 1.0 mm (0.04 inch)