SEAL-U-CUP 3336479 - Caterpillar

Loosen clamp (12). Remove hose (11) from adapter (13).
Install Tool (D) on the inlet side of Tool (A) on adapter (13) in the vibratory motor.
Install Tool (C) from outlet side of Tool (A) onto hose (11).
Move engine start switch (8) to the START position. Release the switch when the engine starts.
Place the engine in high idle.
Operate the hydraulic system until the oil temperature reaches the test temperature of 45 °C (113 °F).
Move parking brake switch (2) to the OFF position.
Illustration 12 g06151958
Use vibratory frequency switch (14) to set the vibratory system in the low frequency/high amplitude mode on both drums.Note: Two things indicate when the vibratory system is in the low frequency/high amplitude mode. First, "Vibratory Frequency Mode Low" will appear on the display. Second, the bottom LED next to vibratory frequency switch (14) will be illuminated.
Illustration 13 g06151961
If necessary, use drum select switch (15) to select both drums.Note: Two things indicate when the machine is in both drums mode. First, "Vibe Drum Select Dual" will appear on the display. Second, both LEDs next to drum select switch (15) will be illuminated.
Set the vibratory system in the manual mode.
Illustration 14 g06151964
Select "Main Menu" (16) on the machine display.
Select "Machine Setup" (17).
Illustration 15 g06151984
Select "Vibe Turn On Speed" (18).
Illustration 16 g06151985
Select "Manual" mode (19).
Launch the Plus+1TM program on the computer to enable the vibe test mode.Note: First time users need to perform the tasks in the Communication and Connections Wizard. This wizard allows the Windows® operating system to recognize the USB device. Follow the on-screen instructions.
Illustration 17 g06151975
Click "Status" icon (20).
Check "Active Codes". Clear any open "Active Codes".
Check "Machine Control" (21).
Illustration 18 g06151972
Click "Hydraulics" (22).
Click "Vibe Test Modes" (23).
Illustration 19 g06151993
Click "Enable" icon (24) to enable the "Normal Vibe Test Mode".
When "Normal Vibe Test Mode" is in "Enabled" mode, the Plus+1TM program is launched.
Illustration 20 g06151998
Standard propel control lever
Illustration 21 g06152000
Optional propel control lever
Press vibratory control switch (25) on the propel lever. The vibratory control switch must be held in the ON position for at least 2 seconds for the vibratory system to actuate.
Read flow on Tool (B). The flow should be between 4.5 L/min (1.2 U.S. gal/min) to 9 L/min (2.3 US gpm).Note: Motor case drain flow cannot be adjusted. If the case drain flow is greater than 9 L/min (2.3 U.S. gal/min), determine the source of excess flow and repair as necessary. If the