SEAL AS 3385202 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    
B     8S-9906     Ratchet Puller     1    Start By:
Drain the hydraulic oil tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".
Remove the bottom guard (rear). Refer to Disassembly and Assembly, "Bottom Guard - Remove".
Drain the oil from the transmission system. Refer to Operation and Maintenance Manual, "Transmission System Oil and Screens - Change/Clean".
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00721568
Disconnect hose (1) from the bottom of the steering pump.
Illustration 2 g00721574
Disconnect hose (2) from the main case and remove the O-ring seal.
Illustration 3 g00721637
Remove bolts (3) and the washers. Remove floorplates (4) .
Illustration 4 g00721596
Disconnect hoses (5), (6), (7), (8), and (9) from the steering pump.
Illustration 5 g00721583
Disconnect hose (10) from the steering pump and remove the O-ring seal. Loosen bolts (13) and rotate hose (10) out of the way. Disconnect hose (11) from the steering pump and remove the O-ring seal. Loosen bolts (12) and position hose (11) out of the way.
Illustration 6 g00721648
Remove bolts (14) from plate (15). Remove plate (15) from the ceiling of the cab.
Illustration 7 g01034297
Install Tooling (A) in the ceiling of the cab. Use a nylon lifting strap in order to attach Tooling (B) to Tooling (A) .
Illustration 8 g00721869
Use a nylon lifting strap in order to attach Tooling (B) to steering pump (16) .
Remove the two twelve point bolts and the washers that hold steering pump (16) to the flywheel housing. Remove steering pump (16) and the O-ring seal from the machine. The weight of steering pump (16) is approximately 80 kg (180 lb).