SEAL-BELLOWS 3432873 - Caterpillar

Torque for all 1/4 in. locknuts (jam nuts) on cable assembly that hold the rod ends in place ... 8 2 N m (6 1.5 lb ft)Torque for the 3/8 in. locknut (jam nut) that holds the swivel rod end on the center rod ... 30 7 N m (22 5 lb ft)Torque for all 5/8 in. locknuts (jam nuts) on cable assembly ... 38 7 N m (28 5 lb ft)Torque for screws that fasten switches (two each) [neutral start (12) and back-up alarm (14)] to the plates ... 0.50 0.05 N m (4 .4 lb in)(4) Torque for four screws ... 8 2 N m (6 1.5 lb ft)(7) Torque for nut ... 8 2 N m (6 1.5 lb ft)(10) Torque for screw ... 25 6 N m (18 4.5 lb ft)(11) Dimension (two places) ... 15 2 mm (.59 .08 in)(12) Attach green wire-#306-to the common (COM) post of the switch assembly and orange wire-#307-to the normally open (NO) post.(13) Dimension ... 16 2 mm (.63 .08 in)(14) Attach brown wire-#321-to the common (COM) post of the switch assembly and black wire-#200-to the normally open (NO) post.(15) 7B5502 Spring: Length under test force ... 24.61 mm (.969 in)Test force ... 22 2 N (5.0 .4 lb)Free length after test ... 33.34 mm (1.312 in)Outside diameter ... 13.84 mm (.545 in)(16) 6Y2846 Spring: Length under test force ... 74.64 mm (2.939 in)Test force ... 626 N (140.8 lb)Free length after test ... 79.92 mm (3.146 in)Outside diameter ... 20 mm (.8 in)(17) Dimension (two places) ... 16 2 mm (.63 .08 in)(18) Torque for three screws ... 1.70 0.25 N m (15 2 lb in)(19) Torque for two screws ... 0.8 0.1 N m (7 1 lb in)(20) Depth to install bearing ... 4.5 1.0 mm (.18 .04 in)(22) Torque for three screws ... 8 2 N m (6 1.5 lb ft)(23) Torque for bolt that tightens collar ... 1.7 0.2 N m (15 2 lb in)(24) Depth to install bearing ... 1.5 1.0 mm (.06 .04 in) See Steering Pilot Valve Tests and Adjustments in the Testing & Adjusting section for the procedure to align pilot valve. Speed Control Adjustment Procedure1. Rotate collar (23) until the number "2" is 30 1 degrees counterclockwise from vertical as viewed from the end of handle (2). Tighten the bolt that holds collar (23) to the specified torque.2. With plate (5) removed, rotate lever (9) until it is parallel with the top of housing (8). Install handle assembly (3) with the white mark in line with the number bq/2" on collar (23). Forward-Reverse Adjustment Procedure1. Rotate ring (21) so screw (22) is in the center of the slot. Tighten two screws (19).2. With parking brake lever (1) in