SEAL-D-RING 3751155 - Caterpillar

(1) Torque for bolts that hold brake drum to pinion flange ... 200 20 lb. ft.(271 27 N m)(2) Torque for the nut on the pinion flange ... 700 100 lb. ft.(949 136 N m)(3) Distance between face of flange and shoulder of pinion ... .124 .030 in.(3.15 0.76 mm) after flange and pinion have been pushed together with a force of ... 35 to 40 ton(311 to 356 kN)(4) Torque for bolts in bearing cage (tighten by hand) ... 100 10 lb. ft.(136 14 N m)(5) Distance between face of sprocket and spline shoulder on hub ... .500 .060 in.(12.7 1.52 mm) after sprocket and hub have been pushed together with a force of ... 60 to 65 ton(534 to 578 kN)(6) Torque for nut on sprocket shaft ... 1100 to 1200 lb. ft.(1492 to 1627 N m)(7) Maximum permissible amount shaft can be bent ... .06 in.(1.52 mm)(8) Torque for nuts that hold sprocket segment to hub (with lubricant on threads) ... 220 40 lb. ft.(298 54 N m) then turn nut an additional ... 120°(9) Tighten nut to a torque of ... 750 50 lb. ft.(1017 68 N m) while the shaft is held with a force of ... 55 to 60 ton(489 to 534 kN)(10) Torque for bolts that hold the final drive case to the steering clutch case (tighten by hand) ... 200 20 lb. ft.(271 27 N m)(11) Distance for shaft installation (from the bearing cup bore in the bevel gear case to the holder assembly. If the bearing cup is installed, it is the distance from the inner edge of the bearing cup to holder assembly) ... 17.258 .062 in.(438.35 1.58 mm) After shaft has been pushed in the case by a force of ... 55 to 60 ton(489 to 534 kN)Maximum amount the sprocket shaft can be bent is .062 in. (1.58 mm). Measure with a square with the sprocket shaft installed in the case.