SEAL-O-RING 3825765 - Caterpillar

Electronic Modular Control Panel 3 EMCP 3
Illustration 1 g01101389
View of EMCP 3
(1) Electronic Control Module (ECM) for the Generator Set
(2) Panel Light Switch
(3) Starting Aid Auto/Manual Switch (optional)
(4) Annunciator Module
(5) Lamp Test Switch
(6) Alarm Acknowledge Switch
(7) Speed Potentiometer (optional)
(8) Emergency Stop Push Button
(9) Alarm Horn For detailed information about the control panel, see Systems Operation, Troubleshooting, Testing and Adjusting, RENR7902, "3508B, 3512B, 3516 and 3516B Engines EMCP3".Electronic Control Module (Generator Set)
Illustration 2 g01045431
(1) Display Screen
(2) AC Overview Key
(3) Engine Overview Key
(4) Yellow Warning Lamp
(5) Red Shutdown Lamp
(6) Alarm Acknowledge Key
(7) Lamp Test Key
(8) Run Key
(9) Auto Key
(10) Stop Key
(11) Up Key
(12) Escape Key
(13) Right Key
(14) Enter Key
(15) Down Key
(16) Left Key Navigation Keys
AC Overview (2) - The "AC OVERVIEW" key will navigate the display to the first screen of AC information. The "AC OVERVIEW" information contains various AC parameters that summarize the electrical operation of the generator set.Engine Overview (3) - The "ENGINE OVERVIEW" key will navigate the display to the first screen of engine information. The "ENGINE OVERVIEW" information contains various engine parameters that summarize the operation of the generator set.Acknowledge Key (6) - Pressing the "ACKNOWLEDGE" key will cause the horn relay to turn off. This will silence the horn. Pressing this key will also cause any red or yellow flashing lights to either turn off or to come on continuously, depending on the active status of the alarms. The "ACKNOWLEDGE" key may also be configured to send out a global alarm silence on the J1939 Data Link, which will silence the horns on the annunciators.Lamp Test Key (7) - Pressing and holding the "LAMP TEST" key will cause each LED and the display screen pixels to turn on continuously until the key is released.RUN Key (8) - Pressing the "RUN" key will cause the engine to enter the "RUN" mode.AUTO Key (9) - Pressing the "AUTO" key will cause the engine to enter the "AUTO" mode.STOP Key (10) - Pressing the "STOP" key will cause the engine to enter the "STOP" mode.Up Key (11) - The "UP" key is used to navigate through the various menus and monitoring screens. The "UP" key is also used when a setpoint is entered. When entering numeric data, the "UP" key is used in order to increment the digits (0-9). If the setpoint requires selection from a list, the "UP" key is used to navigate UP through the list.Escape Key (12) - The "ESCAPE" key is used in order to navigate through the menus. When the key is pressed, the user moves backward or the user moves upward through the menus. The "ESCAPE" key is also used to exit out of entering data when the user is programming the setpoints. If the "ESCAPE" key is pressed while the users is programming the setpoints, none of the changes made on the screen will be saved to memory.Right Key (13) - The "RIGHT" key is used during setpoint adjustment. The "RIGHT" key is used to select which digit is edited while entering numeric