SEAL-O-RING 3895234 - Caterpillar

Illustration 3 g06221498
Section B-B
Table 2
Item Qty Part Specification Description
3 8 160-5875 Lip Type Seal Before assembly, lubricate the sealing lip lightly with moly grease.
4 1 248-2526 Pin Before assembly, apply GL-5 gear oil to the pin diameter and to the bearing inside diameter.
Add black 5P-0960 Grease Cartridge Moly grease through grease hardware until lubricant exudes from each seal.
Diameter is 179.80 0.05 mm (7.079 0.002 inch).
Illustration 4 g06221523
Section C-C
Table 3
Item Qty Part Specification Description
5 As required, use the plates to achieve a clearance (J) of 0.5 to 1.0 mm (0.02 to 0.04 inch) at the closest point between the outside face of the insert and the backside face of the corresponding end plate.
2 310-1678 Plate Thickness is 0.4 mm (0.02 inch).
2 272-8140 Plate Thickness is 0.8 mm (0.03 inch).
10 246-6629 Plate Thickness is 1.6 mm (0.06 inch).
6 As required, use the following shims to reduce the gap to less than 1.0 mm (0.04 inch):
2 139-6380 Shim Thickness is 3 mm (0.1 inch).
3 139-4267 Shim Thickness is 1.0 mm (0.04 inch).
7 24 137-3301 Bolt Before assembly, apply red Loctite 263 to the threads.(1)
8 1 444-1822 Cartridge As Before assembly, apply Loctite C5A Copper Antiseize to the bores.
(1) Before applying sealant, clean all the bolts.
Illustration 5 g06221551
Section D-D
Illustration 6 g06221553
Section E-E
Table 4
Item Qty Part Specification Description
9 40 9X-8273 Bolt Before assembly, apply red Loctite 263 to the threads.(1)
10 2 444-1810 Cartridge As Before assembly, apply Loctite C5A Copper Antiseize to the bores.
(1) Before applying sealant, clean all the bolts.
Illustration 7 g06221555
Section F-F
Table 5
Item Qty Part Specification Description
11 1 248-2527 Pin Before assembly, apply GL-5 gear oil to the pin diameter and bearing inside diameter.
Diameter is 179.80 0.05 mm (7.079 0.002 inch).