SEAL-O RING 3E6741 - Caterpillar

Removal Procedure
Start By:
Remove the radiator group, if necessary.
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g01931919
Remove bolt (1). Remove clip (2) and hose (3) from the water pump.
Loosen hose clamp (4) and disconnect hose (5) from the water pump.
Illustration 2 g01931920
Loosen hose clamp (6) and slide hose (7) away from the elbow.
Illustration 3 g01931923
Remove the bolt and clip (9) to disconnect the harness assembly from elbow (10).
Remove bolts (8) and bolts (12). Remove elbow (10), water pump (13), and the gasket from the engine.
Remove bolts (11). Remove elbow (10) and the gasket from water pump (13).