SEAL 3G9200 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Air Inlet Filter - Inspect/Clean/Test
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Fuel System - Prime
Generator - Dry
Generator Set - Test
Generator Set Alignment - Check
Generator Winding - Test
Varistor - Inspect
Daily
Control Panel - Inspect/Test
Coolant Level - Check
Engine Oil Level - Check
Generator Load - Check
Power Factor - Check
Walk-Around Inspection
Every Week
Alternator - Inspect
Battery Charger - Check
Battery Electrolyte Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Generator Bearing Temperature - Test/Record
Space Heater - Test
Standby Generator Set Maintenance Recommendations
Stator Winding Temperature - Test
Voltage and Frequency - Check
Every 6 Months
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Heat Shield - Check/Replace
Stator Lead - Check
Every Year
Coolant Sample (Level 2) - Obtain
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Engine Valve Lash - Check
Fuel Injector - Inspect/Adjust
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Generator Bearing - Inspect
Generator Bearing - Lubricate
Generator Set Vibration - Inspect
Generator Set Vibration - Test/Record
Generator Winding Insulation - Test
Hoses and Clamps - Inspect/Replace
Prelube Pump - Inspect
Radiator - Clean
Speed Sensor - Clean/Ins