SEAL-O-RING 3J7354 - Caterpillar

Engine Information
The 3406C Generator Set Engine is an in-line six cylinder engine with direct fuel injection.A hydramechanical governor controls the fuel injection pump output. The output maintains the desired engine speed. An automatic timing advance provides the best fuel injection timing over the full range of engine speeds.The fuel ratio control is located on the governor. The fuel ratio control restricts the fuel rack movement. Only the proper amount of fuel is allowed to be injected into the cylinders during acceleration. This minimizes exhaust smoke.Inlet air is filtered by an air cleaner. The air is compressed by a turbocharger before the air enters the engine cylinders. The turbocharger is driven by engine exhaust. The standard engine is turbocharged with jacket water aftercooling.The engine is a four cycle engine. Each cylinder head has two inlet valves and two exhaust valves. The rocker arms and the valves are actuated by the camshaft. The action is performed by mechanical lifters and pushrods.Engine Cooling and Lubrication
The cooling system consists of the following components:
A centrifugal pump that is driven by gears
A thermostat which regulates the engine coolant temperature
An oil cooler
A radiator or expansion tank (incorporating a shunt system)The engine lubricating oil, that is supplied by a gear type pump, is cooled. The engine lubricating oil is also filtered. Bypass valves provide unrestricted flow of lubrication oil to the engine components during the following conditions:
High oil viscosity
Plugged oil cooler or plugged oil filter elements (paper cartridge)Engine efficiency, efficiency of emission controls and engine performance depend on adherence to proper operation and maintenance recommendations. Engine performance and efficiency also depend on the following items:
Use of recommended coolant/antifreeze
Use of recommended fuels
Use of recommended lubrication oilsRefer to the recommended Maintenance Interval Schedule in this publication in order to maintain the following emission related components:
Air cleaner
Engine oil
Oil filter
Fuel
Fuel filterEngine Specifications
Note: The front end of the engine is opposite the flywheel end of the engine. The left and the right sides of the engine are determined from the flywheel end. The number 1 cylinder is the front cylinder.
Illustration 1 g00284836
Cylinder and valve locations
(A) Inlet valves
(B) Exhaust valves
Table 1
3406C Industrial Engine Specifications
Cylinders and Arrangement 6 cylinder in-line block
Bore 137 mm (5.4 inch)
Stroke 165 mm (6.5 inch)
Compression Ratio 14.5:1
Aspiration TA(1)
Displacement 14.6 L (893 in3)
Firing Order 1-5-3-6-2-4
Rotation (flywheel end) Counterclockwise
(1) Turbocharged Aftercooled