SEAL 3K6455 - Caterpillar

Injury to personnel can result if they are not in the operator's view. Allow only essential personnel near the machine, and make sure the personnel are in the operator's view when testing, to prevent injury. Make sure checks are done in an open area.
To prevent injury or death, never work under a machine while a test is being performed.
Personal injury or death can result from lifting a heavy component.The heavy component can fall if using an incorrect hoist and/or sling or fastener to lift the load.Be sure the hoist and other devices have the correct lifting capacity to lift a heavy component. The approximate weight of the heavy component is given below.
Table 1
AP-1000 Asphalt Paver with Extend-A-Mat 10-20WB Screed    
Approximate Weight    
18728 kg (41288 lb)    
Table 2
Required Tools    
Tool    Part Number    Description    Qty    
A (1)     1U-7771     Tachometer     1    
B (1)     1U-6605     Reflective Tape     1    
C     4C-6500     Digital Thermometer     1    
( 1 ) Tool (A) and Tool (B) are part of the 1U-6602 Photo-Tachometer .
Drive the machine to a smooth, horizontal surface.
Illustration 1 g01202856
Move propulsion lever (2) to the NEUTRAL position.
Rotate speed dial (3) to the MINIMUM position.
Move travel mode switch (6) to the PAVE position.
Move parking brake switch (4) to the ON position.
Move screed lower switch (7) to the RAISE position. Completely raise the screed.
Illustration 2 g01214668
Engage screed lock mechanism (8) on both sides of the machine.
Move throttle control switch (5) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (1) to the OFF position.
Illustration 3 g01214669
Move key switch (9) to the OFF position.
Use a suitable lifting device in order to raise the machine. For this test, the machine must be adequately supported. Both tracks must be off of the ground.
Illustration 4 g01214670
Place a small strip of reflective tape (Tool (B) ) on