SEAL 3V5479 - Caterpillar

Illustration 1 g02717559
Schematic of the Implement Valve #1 Extend and Retract (Blade) SolenoidsThis diagnostic code is associated with the Implement Valve #1 Retract (Blade) Solenoid. The FMI 05 means that the ECM has detected that the current for the solenoid circuit is below normal.Note: The diagnostic code is transmitted from the Blade Control to the Machine ECM over the CAN 0 Data Link.Conditions that cause this diagnostic code to be activated are:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. The failure of the ECM is unlikely. Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. After making any possible fix to the circuit, attempt to actuate the solenoid in order to determine if the Diagnostic Code still exists. Some Diagnostic Codes may not display until the engine is running.System Response:When this diagnostic code is active, the following occurs:
The Blade system is disabled.
A Level 1 warning is generated.Test Step 1. CHECK THE SOLENOID
Disconnect the solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire U702-YL) to contact 2 (wire 200-BK).
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the CID 1463 FMI 05 diagnostic code.Expected Result:The CID 1463 FMI 05 diagnostic code is no longer active. A CID 1463 FMI 06 diagnostic code becomes active when the jumper wire is connected.Results:
YES - The CID 1463 FMI 05 diagnostic code is no longer active. A CID 1463 FMI 06 diagnostic code becomes active when the jumper wire is connected. The solenoid has failed.Repair: Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOP
NO - The CID 1463 FMI 05 diagnostic code remains active. The jumper wire does not affect the status of the active diagnostic code. The solenoid is not causing the problem. Proceed to Test Step 2.Test Step 2. CHECK THE CIRCUIT FOR AN OPENThe jumper wire that was installed in the previous Test Step remains in place.
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness connector from the Blade Control.
At the machine harness connector for the Blade Control, measure the resistance from contact 11 (wire U702-GY) to contact 1 (wire 200-BK).
While observing the multimeter resistance measurements, wiggle the machine harness connectors for the Blade Control and the solenoid. Gently pull on the wires and move the wires all around.Expected Result:The resistance measurement is less than 5.0 ohms at all times during the manipulation of the