SEAL 4205735 - Caterpillar

Welding
Non-Engine End Frame (NEEF)
Illustration 1 g06020638
Front view of NEEF
(1) 9C-4935 Plate
(A) 530 2 mm (20.8 0.07 inch)
(2) 125-9738 Block
(B) 599 2 mm (23.5 0.07 inch)
(C) 1439 2 mm (56.6 0.07 inch)
(D) 198 2 mm (7.79 0.07 inch)
(E) 401 2 mm (15.7 0.07 inch)
(F) 895.3 2 mm (35.24 0.07 inch)
(G) 589 2 mm (23.1 0.07 inch)
(H) 196 2 mm (7.71 0.07 inch)
(J) 392 2 mm (15.43 0.07 inch)
(W1) 8 mm (0.3 inch) Fillet weld on both sides
(W2) 6 mm (0.2 inch) Fillet weld
Weld four plates (1) to the NEEF. as per dimension shown in Illustration 1 .
Weld four blocks (2) to the NEEF. as per dimension shown in Illustration 1 .Lift Cylinder Baffles Installation on Non-Engine End Frame (NEEF)
Note: Use proper lifting device as necessary to support components during installation.
Illustration 2 g06020640
(3) 454-5263 Guard As
(4) 8T-4136 Bolt
(5) 8T-4121 Hard Washer
Install guard assembly (3) using four bolts (4) and four hard washers (5).
Illustration 3 g06020641
(4) 8T-4136 Bolt
(6) 454-5258 Plate As
(7) 7X-7729 Hard Washer
Install two plate assemblies (6) using eight bolts (4) and eight hard washers (7).
Illustration 4 g06020642
(4) 8T-4136 Bolt
(5) 8T-4121 Hard Washer
(8) 364-7222 Plate As
Install two plate assemblies (8) using four bolts (4) and four hard washers (5).
Illustration 5 g06020644
(7) 7X-7729 Hard Washer
(8) 364-7222 Plate As
(9) 396-2733 Baffle
(10) 364-7227 Plate
(11) 8T-4196 Bolt
Install two baffles (9) onto two plate assembly (8) using two plates (10), six bolts (11) and six hard washers (7).
Illustration 6 g06020645
(6) 454-5258 Plate As
(7) 7X-7729 Hard Washer
(9) 396-2733 Baffle
(11) 8T-4196 Bolt
(12) 364-7228 Plate
Install two plates (12) in between two baffles (9) and two plate assemblies (6) by using eight bolts (11) and eight hard washers (7).