SEAL-U-CUP 4214025 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g03340806
Disconnect harness assembly (1) and harness assembly (2) from the engine wiring harness assemblies.
Remove harness assembly (1) and harness assembly (2) from the fuel priming pump bracket.
Use a suitable tool in order to remove governor control (3) from cylinder block (5).
Remove sealing washer (4) (not shown). Installation procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Ensure that all components are clean and free from wear or damage. If necessary, replace any components that are worn or damaged.
Illustration 2 g03340806
Install a new sealing washer (4) (not shown) onto governor control (3).
Install governor control (3) to cylinder block (5) hand tight. Ensure that the governor control is installed squarely into the cylinder block.
Use a suitable tool in order to tighten governor control (3) to a torque of 22 N m (195 lb in).
Connect harness assembly (1) and harness assembly (2) to the engine wiring harness assemblies.
Install harness assembly (1) and harness assembly (2) to the fuel priming pump bracket.
Illustration 3 g03340809
Trim code position
If a new governor control (3) has been installed, record the trim code from Position (X) on the new governor control, the trim code should be programmed into the Electronic Control Module (ECM). Use the electronic service tool to input the trim code for the governor control. The trim code is printed on the solenoid in the following format: "AXXX BXXX CXXX".