4364443 SEAL-O-RING Caterpillar parts
MH3037
Rating:
Alternative (cross code) number:
CA4364443
436-4443
4364443
CA4364443
436-4443
4364443
Weight: 0.01 pounds 0 kg.
MATERIAL HANDLER,
Compatible equipment models: 4364443:
Number on catalog scheme:
15
For full view, you need register
Information:
Illustration 1 g02192112
Schematic of the Air Temperature Control Panel
This diagnostic code is associated with the air temperature control panel. The FMI 03 diagnostic code means that the Brake ECM has determined that the voltage of the circuit is above normal. The possible causes of this diagnostic code are listed below:
The signal circuit is open.
The signal circuit is shorted to the +battery circuit.
The control has failed.
The power circuit or the return circuit has failed.
The Brake ECM has failed. A failure of the ECM is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 2661 FMI 03 is active before performing this procedure.Note: Use a digital multimeter for the measurements in this procedure.System Response:A level 1 warning will be generated.Test Step 1. CHECK FOR POWER AT THE CONTROL.Note: Use a digital multimeter for the measurements in this procedure.
Do not disconnect the harness connector from the control panel.
Turn the key start switch and the disconnect switch to the ON position.
At the back of the harness connector for the control panel, insert a multimeter probe along the voltage supply wire (124-GN(Green)) (contact 1).
Measure the voltage from contact 1 to frame ground. Expected Result:The voltage is 24 VDC.Results:
OK - The voltage is 24 VDC. Proceed to Test Step 2.
NOT OK - The voltage is not 24 VDC. The power supply circuit of the control panel in the machine harness has failed.Repair: Check the fuse for the control panel. Replace or repair the machine harness.STOPTest Step 2. CHECK THE RETURN CIRCUIT OF THE CONTROL PANEL.
Disconnect the machine harness for the Brake ECM at the J1 connector.
Turn the key start switch and the disconnect switch to the OFF position.
Remove the multimeter probe from the voltage supply wire (contact 1).
At the back of the harness connector for the control panel insert a jumper wire at the return wire of the signal (J764-BR(Brown)) contact 10 that is long enough to reach the Brake ECM.
Measure the resistance from contact J1-32 to the end of the jumper wire that is connected to contact 10. Expected Result:The resistance is
Caterpillar parts catalog:
Parts seal Caterpillar catalog:
10 FT, 10-20B, 120H, 120H ES, 120H NA, 120K, 120M, 120M 2, 12H, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 135H, 135H NA, 140H, 140K, 140M, 140M 2, 140M 3, 140M 3 AWD, 143H, 14H, 14M, 160H, 160K, 160M, 160M 2...
10 FT, 10-20B, 120H, 216, 228, 236, 245, 248, 24H, 267, 311F LRR, 3126, 3126B, 3126E, 3208, 3408E, 3412E, 3616, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L, 420E, 428F, 430E, 432E, 43...
12H, 140M, 140M 2, 160M, 160M 2, 2290, 2390, 2391, 2491, 2590, 311F LRR, 312E, 316E L, 318E L, 3208, 320D L, 320D2, 320D2 L, 320E L, 320E LN, 323D2 L, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E...
120K, 120K 2, 120M, 120M 2, 12H, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 140G, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 2290, 2384C, 2390, 2391, 248...
414E, 416E, 416F, 420E, 420F, 422E, 422F, 428E, 428F, 430E, 430F, 432E, 432F, 434E, 434F, 442E, 444E, 444F, 450E, 450F, 550, 550B, 560B, 570, 570B, 580, 580B, 583T, 587R, 587T, 793B, 793C, 797, 901C, ...
12M 2, 24M, 2864C, 3126B, 312D2, 312D2 GC, 312D2 L, 313D2, 313D2 LGP, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 3406B, 3406C, 3406E, 3456, 349E, 349E L, 349E L HVG, 349E L VG, 349F L, ...
120M 2, 12M 2, 12M 3 AWD, 140M, 140M 2, 140M 3 AWD, 160M, 160M 2, 160M 3 AWD, 2470C, 2570C, 2670C, 2864C, 311D LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314D C...
3208, 330C, 330C FM, 330C L, 330C MH, 330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L, 349E, 3...
554, CP-433B, M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318, M318C, M318C MH, M318D, M318D MH, M320, M322C, M322D, M322D MH, M325C MH, M325D L MH, M325D MH, M330D, MH303...
M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318, M318C, M318C MH, M318D, M318D MH, M320, M322C, M322D, M322D MH, M325C MH, M325D L MH, M325D MH, M330D, MH3037
320B FM LL, 320C, 320C FM, 325B L, 325C, 325C L, 325D L, 325D MH, 330B L, 330C, 330C L, 330C MH, 330D MH, 345B, 345B II, 345B II MH, 345B L, 345C, 345C MH, 365B, 365B II, 365C L MH, 375 L, 385C L MH, ...
307, 307B, 307C, 307D, 308D, 308E CR, 311, 311B, 311C, 311D LRR, 311F LRR, 312, 312B, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314C, 314D LCR, 315, 315D L, 316E L,...
4364438
SEAL-O-RING
MH3037
MH3037
4364432
SEAL-O-RING
MH3037
MH3037
4364430
SEAL-O-RING
MH3037
MH3037
4364429
SEAL-O-RING
MH3037
MH3037
3959819
SEAL-O-RING
MH3037, MH3049, MH3059
MH3037, MH3049, MH3059
3959818
SEAL-O-RING
MH3037, MH3049, MH3059
MH3037, MH3049, MH3059
3959435
SEAL-O-RING
MH3037
MH3037
3959437
SEAL
MH3037
MH3037
4364453
SEAL-O-RING
MH3037
MH3037
4364450
SEAL-O-RING
MH3037
MH3037
4364449
SEAL-O-RING
MH3037
MH3037
4364446
SEAL-O-RING
MH3037
MH3037