SEAL-O RING 4420365 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01033540
Loosen clamps (1) and disconnect hose (2) .
Loosen clamps (12) and disconnect hose (13) .
Remove bolt (6) and the clip from bracket assembly (7) .
Disconnect tube assembly (3) .
Disconnect tube assembly (5) .
Remove bolts (10). Remove fuel cooler (9). Remove clips (4) and the grommets from the fuel cooler.
Remove bolts (8) and bracket (11) from the cylinder block.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01033540
Position bracket (11) on the cylinder block and install bolts (8) .
Install the grommets and clips (4) on fuel cooler (9). Position the fuel cooler on the bracket and install bolts (10) .
Install the grommets and clips (4) on the fuel cooler. Position fuel cooler (9) and install bolts (10) .
Connect tube assembly (5) .
Connect tube assembly (3). Install the clip and bolt (6) on bracket assembly (7) .
Connect hose (13). Tighten clamps (12) .
Connect hose (2). Tighten clamps (1) .