SEAL 4434345 - Caterpillar

Prelube Time
The parameter sets the amount of time for prelubrication. Programming this parameter to 0 will disable this function.
Table 7
Minimum     Default     Maximum    
0 seconds     0 seconds     210 seconds    Crank Duration
The crank duration determines the amount of time that the starting motors will be engaged. Programming this parameter to 0 will prevent the ECM from engaging the starting motors.Note: Program this parameter to 0 if EMCP II is connected to this system. Problems may result if both controls try to perform this function.
Table 8
Minimum     Default     Maximum    
0 seconds     0 seconds     60 seconds    Cranking Cycles
This parameter is the total number of crank cycles that can be performed.
Table 9
Minimum     Default     Maximum    
0     0     10    Crank Terminate Speed
This parameter determines the engine rpm that the starting motors will disengage.
Table 10
Minimum     Default     Maximum    
100 rpm     400 rpm     500 rpm    Air Shutoff
Programming the parameter to "OFF" will disable the air shutoff. Program this parameter to "OFF" if the function is not being used or installed on this engine. This will prevent diagnostics from being logged.
Table 11
Minimum     Default     Maximum    
OFF     OFF     ON    Ether Control
Programming this parameter to "OFF" will disable the function. Program this parameter to "OFF" if the function is not being used or installed on this engine. This will prevent diagnostics from being logged.
Table 12
Minimum     Default     Maximum    
OFF     OFF     ON    Engine Cooling System
This parameter determines the configuration of the cooling system. This parameter requires a factory password to change.
Table 13
Minimum     Default     Maximum    
SCAC     SCAC     JWAC    Fuel Correction Factor
The parameter is programmed to a numerical value. The calculations will be adjusted in accordance with the numerical value. The parameter requires a factory password to change.Cat Data Link
This parameter determines the engine identification for the secondary Cat Data Link.
Table 14
Minimum     Default     Maximum    
Engine Control 1     Engine Control 1     Engine Control 8    Cold Mode Cylinder Cutout
This parameter provides the ability to enable the cold mode cylinder cutout.
Table 15
Minimum     Default     Maximum    
Disabled     Disabled     Enabled    Direct Fuel Control Mode
If you program the parameter to "ON", you will enable the direct fuel control mode. The parameter requires a factory password to change. This feature requires special hardware in order to operate properly.
Table 16
Minimum     Default     Maximum    
OFF     OFF     ON