SEAL-PISTON 4734066 - Caterpillar

Check Electrolyte Level
Tighten the battery retainers every 1000 hours on all batteries.Check the following at least every 1000 hours, and more often as conditions require:* Clean the top of the batteries with a clean cloth.* Keep the terminals clean and coated with petroleum jelly.At the proper charging rate, in a moderate climate, a battery should not require more than 30 cc (1 ounce) of water per cell per week.Check the cells weekly in extreme temperatures, cell water usage could be higher. 1. Open the access doors located on each side of the machine at the rear for access to the battery. 2. Clean the battery surface with a clean cloth. Keep the terminals clean and coated with petroleum jelly. Install the post cover after coating.3. Inspect the electrolyte level in each battery cell, except maintenance free. Maintain the level to the bottom of the fill openings with distilled water. If distilled water is not available, use clean drinking water.4. Close the access cover.Radiator
Clean or Replace Pressure Cap
The radiator cap access door is located on the top rear of the machine. 1. Open the radiator cap access door. 2. Remove the radiator cap slowly to relieve pressure.3. Inspect the cap for damage, deposits or foreign material. clean the cap with a clean cloth or replace the cap as necessary.4. Install the cap.5. Close the access door.Clean Outside of Radiator Core
Open the radiator guard on the rear of the machine. Compressed air, high pressure water or steam can be used to remove dust, leaves and general debris from a radiator. Clean as required by condition of radiator.The use of compressed air is preferred.Refer to "Know Your Cooling System," Form SEBD0518, for the complete procedure and instructions.Fuses
Replace
The fuse panel is located inside the operator's compartment on the right side of the operator's seat in the operating console. Fuses - They protect the electrical system from damage caused by overloaded circuits. Change a fuse if the element separates. If the element of a new fuse separates, have the circuit checked and repaired.
Replace fuses with the same type and size only. Otherwise, electrical damage can result.If it is necessary to replace fuses frequently, a electrical problem may exist. Contact your Caterpillar dealer.
Tail Light - Lefthand (1) - 10 amps. Tail Light - Righthand (2) - 10 amps. Back-up Alarm (3) - 10 amps. Lift and Tilt Kickouts (4) - 10 amps. Flood Light - Righthand (5) - 10 amps. Gauges (6) - 10 amps. 12 Volt Converter (7) - 10 amps. Flood Lights - Auxiliary (8) - 10 amps. Implement (9) - 10 amps. Supplemental Steering (10) - 10 amps. Electronic Monitoring System (EMS) (11) - 10 amps. Lighter (12) - 10 amps. Windshield Wiper - Front (13) - 10 amps. Windshield Wiper - Rear (14) - 10 amps.Windshield Wipers and Washer
Inspect/Replace
Inspect the windshield wiper blade. Replace if it is worn or damaged, or if streaking occurs.Fill Washer Bottle
When operating