SEAL-O-RING 4876143 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite Nickel Anti-Seize Lubricant -
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool.
Wear goggles, gloves, protective clothing, and a National Institute for Occupational Safety and Health (NIOSH) approved P95 or N95 half-face respirator when handling a used Diesel Particulate Filter or Catalytic Converter Muffler. Failure to do so could result in personal injury.
Illustration 1 g06045608
Remove ladder (3), bolts (2), and panel assembly (1).
Illustration 2 g06045616
Disconnect tube assembly (4). Loosen clamps (6) and (7).
Illustration 3 g06045621
View from under machine.
Remove bolts (7) and panel (8).
Illustration 4 g06045627
Remove temperature sensor (9). Remove clamp (10) and inlet module (5).Installation Procedure
Note: When installing a new inlet module (catalyst) or a cleaned inlet module (catalyst), a DOC reset must be performed. Refer to Special Instruction, REHS8180, "Aftertreatment Filter Maintenance on Tier 4 Final Products Equipped with a Diesel Particulate Filter (DPF), Diesel Oxidation Catalyst (DOC), and a Selective Catalyst Reduction (SCR) Filter" for the correct procedure.
Install inlet module (catalyst) (5) in the reverse order of removal.
Illustration 5 g03651915
Facing the Inlet Module Assembly.
Install clamp (7) to Dimension (Y). Dimension (Y) is 30° 5°. Tighten clamp (7) to a torque of 60 5 N m (44 4 lb ft).
Illustration 6 g03651916
Typical Example
Note: Do not use power tools in order to torque strap (6).
Apply Tooling (A) to the threads of strap (6) along Distance (Z). Distance (Z) is 25 mm (1.0 inch) above the trunnion. Tighten strap (6) to a torque of 15 + 3 - 0 N m (133 + 27 - 0 lb in).
Illustration 7 g03651920
Cutaway view of band clamp (10) in position on the assembly.
Note: Do not use power tools in order to torque band clamp (10).
Verify that the cup of the Ball Joint (G) does not touch the radius of the Ball (F). Position band clamp (10) and hand tighten band clamp (10). Band clamp (10) should be in the center of the joint.
Dimension (D) and Dimension (E) should be equal within 2.0 mm (0.08 inch). Repeat the measurements every 90° around band clamp (10). If necessary, adjust band clamp (10).
Torque band clamp (10) to a torque of 35 2 N m (26 1 lb ft).
Apply Tooling (A) to the threads of temperature sensor (9). Tighten temperature sensor (9) to a torque of 45 5 N m (33 4 lb ft).