4T5699 SEAL Caterpillar parts
235C, 245, 245B
Rating:
Alternative (cross code) number:
CA4T5699
4T-5699
4T5699
CA4T5699
4T-5699
4T5699
Weight: 0.010 pounds 0 kg.
EXCAVATOR,
Number on catalog scheme:
17
For full view, you need register
Information:
Illustration 4 g00811094
Label all the wires on the static switch interface board (11) .
Disconnect the connector for the 24 VDC power supply from "J7" terminal (18) that is located at the rear of the board.Note: Terminal "J7" (18) can not be seen from the front of the unit.
Disconnect the "APC" input/output connector from terminal "J1" (15) that is located at the rear of the board.
Disconnect the External Thermistor connector from the terminal "J9" that is located at the rear of the board.
Disconnect the "A" connector from terminal "J8" (12) .
Disconnect the "A" connector from terminal "J6" (13) .
Disconnect the "B" connector from terminal "J5" (14) .
Disconnect the "B" connector from terminal "J4" (16) .
Disconnect the "C" connector from terminal "J3" (17) .
Disconnect the "C" connector from terminal "J2" (19) .
Remove the 4 mounting screws and remove the board.
Label the power cables on the terminals for the static switch input for the following phases: A, B and C. Label the power cables on the terminals for the static switch output for the following phases: A, B and C.
Disconnect the power cables from each input terminal. Disconnect the power cables from each output terminal. Power cables must be disconnected from the following phases: A, B and C.
Loosen the two mounting bolts at the top of the static switch module.Note: Do not remove the two mounting bolts.
Remove the static switch.
Illustration 5 g00811130
Label all the wires on the assemblies for the power supply.
Disconnect the red wire from terminal "J35" (25) on the "PWD".
Disconnect the black wire from terminal "J46" (26) on the "PWD".
Disconnect the red wire from terminal "J8" (24) on the "PWD".
Disconnect the black wire from terminal "J40" (23) on the "PWD".
Disconnect the black wire from terminal "J41" (33) on the "PWD".
Disconnect "SK3" (27) from power supply 1.
Disconnect "SK3" (29) from power supply 2.
Disconnect the wires from the 2 capacitors that are located below the power supplies.Note: Short the capacitor terminals by using a shorting stick to ensure that the capacitors are discharged and do not cause a shock hazard.
Disconnect the 2 ground wires that are green from the chassis.
Remove the top 2 mounting bolts (28) and (31) from the Power Supplies.
Loosen the bottom 2 mounting bolts (30) and (31) from the Power Supplies.Note: Do not remove the 2 bottom mounting bolts.
Remove the Power Supply.Installation of Power Supply
Illustration 6 g00811130
Install the power supply onto the bottom 2 mounting bolts (30) and (31) .
Insert the top 2 mounting bolts (29) and (32) and tighten all of the bolts.
Connect the 2 green ground wires to the chassis and tighten.
Connect the wires to the 2 capacitors that are located below the power supplies.
Connect "SK3" (27) to power supply 1.
Connect "SK3" (29) to power supply 2.
Connect the black wire to terminal "J41" (33) on the "PWD".
Connect the black wire to terminal "J40" (23) on the "PWD".
Connect the red wire to terminal "J8" (24) on the "PWD".
Connect the black wire to terminal "J46" (26) on the "PWD".
Connect the red wire to terminal "J35" (25) on the "PWD".
Illustration 7 g00811094
Install the
Caterpillar parts catalog:
Parts seal Caterpillar catalog:
120B, 120G, 12F, 12G, 12H, 12H ES, 12H NA, 130G, 140, 140B, 140G, 140H, 140H ES, 140H NA, 141, 143H, 14E, 14G, 14H, 14H NA, 153, 16, 160G, 160H, 160H ES, 160H NA, 163H, 163H NA, 1673C, 16G, 16H, 16H N...
140G, 140H, 143H, 14H, 153, 160H, 163H, 16H, 225, 225D, 229, 231D, 235, 235B, 235C, 235D, 245, 311D LRR, 3126B, 312D, 312D L, 313D, 314D CR, 314D LCR, 315C, 315D L, 3176, 3176B, 318D L, 319D, 319D L, ...
120G, 120M, 12H, 12M, 12M 2, 12M 3, 12M 3 AWD, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 183B, 193, 215, 231D, 235, 235B, 235D, 245, 24H, 24M, 30/30, 3114, 3116, 31...
10 FT, 10-20B, 120H, 216, 228, 236, 245, 248, 24H, 267, 311F LRR, 3126, 3126B, 3126E, 3208, 3408E, 3412E, 3616, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L, 420E, 428F, 430E, 432E, 43...
245, 3406, 3408, 3412, 589, 594H, 621, 637D, 651E, 657E, 777, 988B, 992C
120G, 12G, 130G, 14G, 16G, 215, 225, 227, 235D, 245, 245B, 245D, 3508, 3508B, 3512, 3512B, 3516, 3516B, 3612, 3616, 5130, 5130B, 5230, 776C, 776D, 777, 777D, 784B, 784C, 785, 785B, 785C, 789B, 789C, 7...
120H, 120K, 120K 2, 120M, 120M 2, 12H, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 135H, 140H, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 143H, 14M, 160H, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 163H, 16M...
1090, 1190, 1190T, 1290T, 1390, 215B, 225, 229, 2290, 235B, 235D, 2390, 2391, 245, 245B, 2491, 24H, 24M, 2590, 311D LRR, 311F LRR, 312D, 312D L, 312D2, 312D2 GC, 313D, 313D2, 314D CR, 314D LCR, 318D L...
235D, 245, 594, 594H, D9G, D9H
225, 245, 631D, 651E, 657E, 966D, 988
214, 224, 245, 322C, 324D FM, 330, 330 L, 330C, 330D L, 330D MH, 345B, 345B II, 345B II MH, 345B L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L HVG, 349E L VG, 3...
235B, 235C, 235D, 245, 245B, 245D
5P1445
SEAL
215B, 910
215B, 910
5P0843
SEAL
215B, 824B, 931, 953B, 992
215B, 824B, 931, 953B, 992
9G5316
SEAL-RING
245
245
2W0436
SEAL
245
245
215B, 225, 227, 229, 231D, 235B, 235D, 245, 245B, FB221
225, 225D, 229, 910, 955H, FB221
9T2283
SEAL
225, FB221
225, FB221
6W5391
SEAL
245, 245B
245, 245B
245