SEAL-O-RING 5086522 - Caterpillar

"Service Meter History"
Use the following procedure in order to view the "Service Meter History":
In order to view the "Service Meter History" for a machine, select a service meter reading for a machine from the "Service Meter (hours)" column on the "Location and Service Meters" screen.
Illustration 7 g01710941
"Service Meter History" (13) "Start Date" field (14) "End Date" field
Change the range of the date, if necessary. Click "Back" in order to return to the "Location and Service Meters" screen."Location History"
Use the following procedure to view the "Location History" of a machine.
In order to view the "Location History" for a machine, select the location of a machine from the "Service Meter (hours)" column on the "Location and Service Meters" screen.
Illustration 8 g01710944
"Location History" (13) "Start Date" field (14) "End Date" field
The "Location History" screen will appear. Change the range of the date, if necessary. Click "Back" in order to return to the "Location and Service Meter" screen."Location Report Frequency"
Product Link is configured to a maximum of four reports of the location per day. The first location report is sent at the Report Start Time. The Position Report Minimum Location Change configuration defines the minimum distance the machine must move since the last report in order for a position report to be sent. If the minimum configured distance has not been met, Product Link will not send a position report. The minimum distance that is permitted is zero meters and the maximum distance is 200 meters. If the parameter is set to zero meters, then the PLM will send a position report 4 times a day regardless of movement. Refer to Systems Operation, Troubleshooting, Testing and Adjusting, RENR7911, "Manage Hardware", and to Special Instruction, REHS2365, "Product Link PL121SRPL121SR and PL300PL300 Installation Guide".Last Known Location
If a valid location from the GPS is not obtained in the given time, the last known location will be displayed in EquipmentManager. This "stale" location will be identified with "(Last Known)" in the "Location and Service Meter" view. Refer to Systems Operation, Troubleshooting, Testing and Adjusting, RENR7911, "Installation Parameters Conifgure" for more information about the GPS Fix Validity Time Duration parameter."Map Locations"
There are two options for creating the map of the location of your machine. The machine can be plotted on a map from either the "Location and Service Meters" screen or from the "Location History" screen.
In order to view the location of a machine on the map from the "Location and Service Meters" screen that is in the "Equipment Information" section, select the check box next to the machine. Refer to Illustration 5.
Click the "Map Locations" button. The "Equipment Location Map" screen will be displayed.
Illustration 9 g01710946
"Equipment Location Map" (15) Marker for the equipment
The location of the machine is plotted on a map with identification of a landmark and a city street. Use the "Zoom In" and "Zoom Out" buttons to change your view of the map. Click near the marker of the equipment (15) that is being viewed in order to center the marker in the window of the