AVSPARE.COM
parts catalog

SEAL-O-RING 5088560 - Caterpillar



5088560 SEAL-O-RING Caterpillar parts SEAL
Rating:
66
Alternative (cross code) number:
CA5088560
508-8560
5088560
Caterpillar 5088560 SEAL-O-RING
Weight: 0.01 pounds 0 kg.

Buy SEAL-O-RING 5088560 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme:
 
  For full view, you need register

Information:

Removal Procedure
Start By:
Remove the left side panel. Refer to Disassembly and Assembly, "Side Panel - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Drain" for the correct procedure.
Illustration 1 g01515138
Loosen clamp (1) and disconnect hose (2) from the water pump inlet.
Illustration 2 g01515141
Typical example
Remove bolts (6). The bolts are different lengths. Note the positions of the different bolts.Note: Do not remove bolts (9) at this time.
Remove water pump (5) from front cover (3) .Note: If necessary, tap water pump (5) with a suitable soft hammer in order to loosen water pump (5) .
Remove gasket (4) .
If necessary, remove cover (8) from water pump (5). Follow Steps 6.a through 6.c in order to remove cover (8) .
Remove bolts (9) .
Remove cover (8) .
Remove gasket (7) .Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     -     Guide Bolt
M8 by 80 mm     2    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01515141
Typical example
If necessary, install cover (8) to water pump (5). Follow Steps 1.a through 1.d in order to install the cover.
Clean the mating surface of cover (8) .
Position a new gasket (7) onto water pump (5) .
Install cover (8) to water pump (5) .
Install bolts (9) to cover (8). Tighten the bolts finger tight.
Clean the mating surface of front cover (3) .
Illustration 4 g01515150
Install Tooling (A) .
Use Tooling (A) in order to align new gasket (4) to front cover (3). Install gasket (4) to the front cover.
Align water pump (5) with Tooling (A). Install water pump (5) to front cover (3) .Note: Ensure that the gear of water pump (5) and the gear of the fuel injection pump mesh.
Install bolts (6). Refer to Illustration 3. Tighten bolts (6) finger tight.Note: Ensure that bolts of different lengths are installed in the correct positions.
Remove Tooling (A) and install remaining bolts (6) finger tight.
Illustration 5 g01515157
Tightening sequence for the water pump
Tighten bolts (6) and bolts (9) to a torque of 22 N m (16 lb ft). Refer to Illustration 3. Tighten the bolts in the sequence that is shown in Illustration 5.
Illustration 6 g01515138
Install hose (2) to the water pump inlet. Tighten clamp (1) .
Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (DEAC) - Change" or Operation and Maintenance Manual, "Cooling System Extended Life Coolant - Change" for the proper filling procedure.End By: Install the left side panel. Refer to Disassembly and Assembly, "Side Panel - Remove and Install".

Caterpillar parts catalog:

Caterpillar parts catalog
D6T Track-Type Tractor XL VPAT, XE; XW VPAT, XE; LGP VPAT, XE D5M00001-UP (MACHINE) POWERED BY C9.3 Engine
D6T Track-Type Tractor XL, XE; XW, XE; LGP, XE HFE00001-UP (MACHINE) POWERED BY C9.3 Engine
D6 Track-Type Tractor LRG00001-UP (MACHINE) POWERED BY C9.3 Engine
D6T Track-Type Tractor XL, XE; XW, XE; LGP, XE B7200001-UP (MACHINE) POWERED BY C9.3 Engine


Parts seal Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.