SEAL 5127948 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 155-3597 Wheel Chock 4
B - Loctite542 -
Use Tooling (A) in order to block the tires and prevent the machine from rolling.
Illustration 1 g03777275
Illustration 2 g03777832
Illustration 3 g03777237
Remove bolts (1) and cover (2). Remove cover (3).
Illustration 4 g03777837
Position the parking brake handle into the released position. Remove the cotter pin and pin assembly (4). Remove bolts (5) and the parking brake handle assembly.
Illustration 5 g03777856
Disconnect pin (6) and cable assembly from parking brake lever assembly.
Illustration 6 g03777919
Loosen jamb nut (8). Remove bolts (7) and parking brake assembly (9). Remove jamb nuts (8).
Remove the parking brake cable through the floor plate in the cab.
Illustration 7 g03777981
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove spring (10) and brake pads (11). Installation Procedure
Install parking brake assembly (9) in the reverse order of removal.
Illustration 8 g03778956
Illustration 9 g03779426
Tighten inner nut (12) to a torque of 13 N m (115 lb in) for field adjustment. Back off inner nut (12) four to six flats. Tighten outer nut (13) against inner nut (12) to a torque of 68 N m (50 lb ft).
Orient lever (14) to dimension (Z). Dimension (Z) is 45 degrees.
Illustration 10 g03779477
Adjust mounting bolt and jam nut (8) to attain Dimension (X) between jamb nut (8) and bushing (15). Dimension (X) should be approximately 1.00 0.5 mm (0.040 0.020 inch). Apply Tooling (B) to jamb nut (8).
After Dimension (X) is attained, tighten jamb nut (8) against the mounting surface to a torque of 108 N m (80 lb ft).