SEAL 5505783 - Caterpillar

Proceed by selecting "Serial FPGA20k" for the target.
Click "Browse". Find the file and select the file apc*.ttf.This file has been saved on a floppy disk or on your hard disk.
Illustration 8 g00846426
Click "Open".
Illustration 9 g03404427
Click "Program".The message "Programming the Flash" will appear on the left of the progress bar. The bar will move from left to right. The bar will display a number that will increase from 0 percent to 100 percent as the bar moves to the right. The message "Firmware update: receiving data" will appear in UPS View at the same time. When the progress bar reaches 100%, the next message in UPS View will be "Firmware update: updating flash". When the progress bar has reset to 0%, the process will begin again with the message "Read Back Flash Program" to the left. When the progress bar has reached 100% then read back checking is finished. The progress bar will reset to 0%. The progress bar will display the message "completed with no errors" on the left. UPS View will display the message "Firmware update: successful".Note: If an error has occurred then press "Program" in order to retry the process.
Illustration 10 g03404430
In the dialog box, click on the down arrow that is located to the right of the