SEAL-SQUARE 5593652 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the engine into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g01199582
Attach a suitable lifting device onto engine oil cooler (1). The weight of engine oil cooler (1) is approximately 150 kg (330 lb).
Illustration 2 g01199583
Remove bolts (3). Disconnect tube assembly (2). Remove bolts (5). Disconnect tube assembly (4).
Illustration 3 g01926428
Illustration 4 g01926429
Remove bolt (6) in order to disconnect clamp (7). Remove bolts (9). Disconnect tube assembly (12). Remove bolts (11). Disconnect tube assembly (10). Check coupling (8) for leaks. Note: Never tighten the bolts in coupling (8) in order to stop the leak. Drain tube assembly (12) and loosen the bolts on coupling (8). Do not remove coupling (8) but pry in order to disengage the teeth in coupling (8). Remove coupling (8) from the joint.
Illustration 5 g01926635
Remove bolts (13) from engine oil cooler (1). Repeat for the opposite side.
Illustration 6 g01199773
Lower engine oil cooler (1) to the ground.