SEAL KT (SEM) 5651107 - Caterpillar

Removal Procedure
Start By:
Remove the fuel manifold. Refer to Disassembly and Assembly, "Fuel Manifold (Rail) - Remove".
Remove the air inlet heater. Refer to Disassembly and Assembly, "Air Inlet Heater - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01375420
Remove bolts (1) and remove clip (2) .
Illustration 2 g01384395
Remove bolt (4) and remove the washers. Discard the washers.
Remove bolts (6) and remove the washers. Discard the washers.
Remove bolts (3) and remove manifold (5) .
Illustration 3 g01384434
Remove clips (7) .
Disconnect harness assemblies (8) .
Remove bolts (10) and remove inlet manifold (9) and the gasket.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the gaskets for wear or for damage. Replace the components, if necessary.
Illustration 4 g01384434
Position the new inlet manifold gasket. Position inlet manifold (9) and install bolts (10). Tighten bolts (10) to a torque of 18 2 N m (13 1 lb ft).
Connect harness assemblies (8) and install clips (7) .
Illustration 5 g01384395
Position manifold (5) and install bolts (3) .
Install new washers and install bolt (4). Tighten bolt (4) to a torque of 34 4 N m (25 3 lb ft).
Install new washers and install bolts (6). Tighten bolts (6) to a torque of 34 4 N m (25 3 lb ft).
Illustration 6 g01375420
Install clip (2) and install bolts (1) .End By:
Install the air inlet heater. Refer to Disassembly and Assembly, "Air Inlet Heater - Remove and Install"
Install the fuel manifold. Refer to Disassembly and Assembly, "Fuel Manifold (Rail) - Install".