SEAL-O-RING 5L4758 - Caterpillar

Engine:
3412C (S/N: RTY1-UP)
3412E (S/N: TGC1-UP)
3512 (S/N: YAK1-UP)
3516 (S/N: ZAL1-UP; YAS1-UP)
Generator Set:
3406 GEN SET (S/N: NKM1-UP)
3406C GEN SET (S/N: ZKC1-UP; C2G1-UP; C8G1-UP; C2Y1-UP)
C18 GEN SET (S/N: NKM1-UP)
Engine News SEBD9899, 25 September 2013, "Signal Converter for Use With Oil Pressure Sensor Is Available for Certain Cat Generator Sets". Disregard the information in the article that is listed above. Refer to the information in the following article. An active signal converter for use with the existing pressure sensor is available for certain Cat generator sets. The signal converter is mounted in the housing for the generator set control panel.Instructions to Connect 417-3764 Signal Converter to the Pressure Sensor
Required Parts
Table 1
Parts List    
Item    Qty    Part Number    Description    
1     1     320-3064     Pressure Sensor    
2     1     417-3764     Signal Converter    
3     1     1J-9671     O-Ring Seal    
4     1     362-1142     Adapter    
5     2     3S-2093     Cable Strap    
6     15     7K-1181     Cable Strap    Perform the following procedure:
Illustration 1 g03330149
(1) 320-3064 Pressure Sensor (2) 417-3764 Signal Converter
Connect one end (A) of the first wired harness to the 320-3064 Pressure Sensor (1) using a three pin 281-8804 Connector Plug As .
Connect the other end (B) of the first wired harness to one end of the 417-3764 Signal Converter (2) using a three pin 102-8803 Receptacle Kit .
Connect the other end of the 417-3764 Signal Converter to one end (C) of the second wired harness using a four pin 155-2271 Connecting Plug Kit .Routing Instructions
Perform the following procedure:
Place all harness wiring in conduit.
Use a knockout to add hole to dog house.
Protect conduit going through hole with a grommet.
Zip tie 417-3764 Signal Converter to existing wiring harness inside doghouse with 3S-2093 Cable Strap .
Place one of the 7K-1181 Cable Straps around center of 417-3764 Signal Converter .
Zip tie conduit to harness as needed with a maximum spacing of 450 mm (18 inch).
Make sure that harness is clipped within 150 mm (6 inch) of each connector.