SEAL-RING 5N2614 - Caterpillar

Illustration 4 g02474297
Follow the instructions in the dialog box before you click the "OK" button.
Park in an open area on level ground.
Clear all personnel from the machine and the area.
Provide adequate clearance for full implement motion.
Lower all attachments.
Ensure that the linkage position sensors are properly calibrated.
Ensure that the implement valve solenoids are properly calibrated.
Illustration 5 g02474299
Select the cycle time checks that you wish to run. Click the "Begin" button.
Illustration 6 g02474298
Begin the RAISE cycle time check. Follow the instructions on the screen.
Engage the parking brake.
Disengage the implement lockout switch.
Position the machine so that the linkage can be safely moved through the full range of motion.
Ensure that the work tool is empty.
Warm the hydraulic oil until the temperature of the oil is between 50 - 80° C (122 - 176° F). Move the implement through the full range of travel while warming the hydraulic oil. Click the "Next" button.
Place the implement in the full TILT BACK position. Click the "Next" button.
Lower the linkage to the minimum position. Click the "Next" button.
Run the engine at high idle.
Release the joystick. Click the "Next" button.
Move the lift control lever into the full RAISE position. Hold the lever in the full RAISE position. Note: The