SEAL 5P0094 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8T-0914 Guide Pin 2
B - Forcing Bolt
3/8 - 16 by 3 inch 3
C 200-5958 Wear Sleeve Installer 1
D - Loctite 620 Retaining Compound - Start By:
Remove vibration damper.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03810747
Use a suitable lifting device to remove shaft (2).
Remove bolts (1) and shaft (2). The weight of shaft (2) is approximately 25 kg (55 lb).
Illustration 2 g03810751
Remove bolts (3).
Illustration 3 g03810781
Use Tooling (B) to remove seal assembly (4) and the O-ring seal.
Illustration 4 g03810795
Install Tooling (A) into crankshaft adapter (6).
Use a suitable lifting device to remove crankshaft adapter (6).
Remove bolts (5) and crankshaft adapter (6). The weight of crankshaft adapter (6) is approximately 97 kg (214 lb).
Illustration 5 g03810810
Use Tooling (C) to remove wear sleeve (7). Installation Procedure
Install wear sleeve (7) in the reverse order of removal.
Apply Tooling (D) to wear sleeve (7).