SEAL-LIP TYPE 5P0884 - Caterpillar

Stick Lowering Control Valve Issue Investigation
Extend out the stick.
Turn OFF the contact key. Position the key at 1.
Move the joystick in order to retract the stick inward.
If the stick does not move in, check the pilot pressure at the SLCV. Ensure that the drain and pilot lines are not inverted.
If the stick does move in but not as expected, replace the SLCV to ensure controllability.
If the stick does move in and moves as expected, investigate root causes other than the SLCV.Stick Drift Issue
Measure the drift. Use the procedures that are listed in Table 2.
Extend the stick fully out and release the joystick.
If the stick is not drifting, install a new line relief valve.
If the stick is still drifting, contact product support and return the valve together with the troubleshooting procedure measurements that are listed in Table 3.
Table 2
Procedure for Drift Measurement    
Prime Product Model    Drift Measure Procedure    
320D     RENR7295    
321D     KENR5775    
323D     RENR9895    
324D     RENR9905    
325D     RENR7385    
328D     KENR5755    
329D     RENR7385    
330D     RENR9679    
Table 3
Measurement Results    
Measurement Name    Measurement Result    
Boom or stick drift measurement    
   
Is the needle valve torqued?
Yes or No        
Pressure measurements at BLCV's        
       
       
       
       
       
       
Illustration 1 g02176666
320D BLCV needle valve location (1) Locknut (2) Check valve
Illustration 2 g01943577
323D, 324D, 325D, 329D BLCV needle valve and balance lines location (3) Needle valve (lowering) (4) Balancing line
Illustration 3 g01943584
323D, 324D, 325D, 329D (5) BLCV needle valve location
Illustration 4 g01943591
330D (6) Location of BLCV need valve (lowering) (7) Location of BLCV balancing lines
Illustration 5 g01943601
330D BLCV needle valve and balancing lines location (8) BLCV needle valve (lowering)
Illustration 6 g02176672
330D (9) BLCV needle valve location
Illustration 7 g01943620
330D SLCV needle valve location
Illustration 8 g01943621
330D SLCV needle valve location (10) Disconnect balance line (11) Install pressure tab at balancing line port
Illustration 9 g01943625
Needle valve torques (12) Tighten to 48 5 N m (35 4 lb ft) (13) Tighten to 2.25 0.25 N m (20 2 lb in) (14) Tighten to 4 0.5 N m (35 4 lb in)